Electronic Unit Injector Sleeve - Remove
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 9U-6891 | 喷油器工具总成 | 1 |
开始:
- 拆下电子单体喷油器。 请参阅拆解和组装, "电子单体喷油器 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 排出发动机中的冷却液。 请参阅操作和保养手册, "冷却系统冷却液 - 更换"。
Show/hide table
图 1 g01076133 - 将工具 (A) 安装到电子单体喷油器套筒 (1) 内。
- 拧紧工具 (A) 上的螺母,直到将电子单体喷油器套筒完全拉离缸盖。
- 将 O 形密封圈 (2) 和 (3) 从电子单体喷油器套筒 (1) 上拆下。
Caterpillar Information System:
G3516B Engines Generator Output Power Sensor
C15 On-highway Engines Electronic Unit Injector - Remove
G3516B Engines Generator Output Power Readings Do Not Match
C11 and C13 Petroleum Engines Lubrication System
C15 On-highway Engines Fuel Transfer Pump - Install
C15 On-highway Engines Fuel Transfer Pump - Remove
G3516B Engines Location of Components
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3600 Engines Speed Sensor
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
C27 and C32 Industrial and Petroleum Engines Electronic Unit Injector Wiring
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
C15 and C18 Industrial Engines Electronic Unit Injector Sleeve - Install
C9 Marine Generator Set Engines Basic Engine
C15 and C18 Industrial Engines Water Lines
G3516B Engines Generator Output Power Sensor - Calibrate
3406E and 3456 Generator Set Engines Crankshaft Rear Seal - Install
C9 Marine Generator Set Engines Finding Top Center Position for No. 1 Piston
C13, C15, and C18 Tier 4 Final Engines Piston and Rings
3406E and 3456 Generator Set Engines Pistons and Connecting Rods - Install
3406E and 3456 Generator Set Engines Connecting Rod Bearings - Install
C15 On-highway Engines Turbocharger - Remove - Low Pressure
C15 On-highway Engines Turbocharger - Install - Low Pressure
C15 On-highway Engines Turbocharger - Remove - High Pressure