Use the 6V6167 Contact Point to Measure Wear Steps on Piston Pins{0653}
Usage:
A general purpose 6V6167 Contact Point is available. The contact point can be used with all dial indicators that have AGD 4-48 threads.
A good use of this contact point is with the 3P1568 Dial Indicator and parts from the 8S2328 Dial Indicator Group to measure profile and wear steps on piston pins. Specifications for these piston pins are shown in Guideline For Reusable Parts, Form SEBF8049.
The 6V6167 Contact Point is 30.0 mm (1.18") long and has a pointed tip with a radius that is about .76 mm (.03").
Wear steps on piston pins can be measured with the 6V6167 Contact Point.
Caterpillar Information System:
1982/11/22 6V4869 Adapter And 6V6174 Plug Can Be Used To Install Camshaft Bearings{1211,0621}
1982/11/15 Repair Kits Available For Air Compressor{1803}
1982/11/15 Crankshaft Has Step At Front Of No. 1 Main Bearing Journal{1202}
1982/11/15 Make Change To 6V2100 Multitach And 5P9698 Calibrator{0651}
1982/11/08 High Compression Pistons Can Be Used In Engines Used At High Altitudes{1214}
1982/11/08 Mechanical Shutoff Groups Changed To Prevent Vibration Of Oil Line Tubes{7418}
1982/11/08 Do Not Center-Tap Batteries In 24-Volt System To Operate 12-Volt Accessories{1400,7300}
1982/11/08 Fabricated Adapter Will Fasten Hydraulic Cylinders To Test Stands{0626,0665,5000}
1982/11/08 6V6175 And 6V6176 Torque Adapters Make Installation Of Fuel Pump Drive Gear Easier{1206,1272,0614}
1982/11/08 New Gears Will Decrease Noise Level{3304}
1982/11/08 Use 6V6147 Polishing Wheel To Clean Piston Pins{0675,1214}
1982/11/08 New Fuel Bleed Valve Used{1262}
1982/11/22 New Seal Used On Governor Control Shaft{1264,1265}
1982/11/22 Service Parts Available For The 5P4150 Nozzle Testing Group{0651,0652}
1982/11/29 Improvements Made To Fuel Ratio Control {1278}
1982/11/29 Use FT1711 Light Table For Cylinder Liner Inspection {0652,1216}
1982/11/29 Inspection Of Equipment After It Has Been In Storage {0355}
1982/11/29 Transmission Pump Failure Can Be Caused By Worn Splines Or Slot In Pump Drive {3153}
1982/11/29 Hose Presses Can Now Be Used To Service 12.7 mm (.50") JIC Couplings {0623,0624,7554}
1982/11/29 New 6V7059 Micrometer Measures Liner Top Flange And Valve Lip {0653,1216,1105}
1982/11/29 New 6V6146 Load Leveler Can Lift Larger Components {0644}
1982/11/29 Removal Of Water Pump Impeller {1361}
1982/11/29 New Flexible Coupling Group Must Be Installed Correctly {3300,3252}
1982/11/29 6V7013 Rivet Roll Set Now Available {0613,0622,3012}