6V6175 And 6V6176 Torque Adapters Make Installation Of Fuel Pump Drive Gear Easier{1206,1272,0614}
Usage:
All 3304 And 3306 Engines
New 6V6175 and 6V6176 Torque Adapters are now available. These adapters are bolted to the fuel pump drive gear. This makes it possible to put a specific torque on the gear with a torque wrench while the bolt in the center is tightened to the correct torque specification.
The 6V6176, which is a replacement for the FT1650 Adapter, is used for engines with automatic timing advance. The 6V6175 is a replacement for the FT1644 Adapter and is used on engines without automatic timing advance.
Caterpillar Information System:
1982/11/08 New Gears Will Decrease Noise Level{3304}
1982/11/08 Use 6V6147 Polishing Wheel To Clean Piston Pins{0675,1214}
1982/11/08 New Fuel Bleed Valve Used{1262}
1982/11/08 Removal Of Hydraulic Override From Fuel Ratio Control{1278}
1982/11/01 Use A 1P90 Wheel Dolly With Repair Stands And Parts Rack Base{0645}
1982/11/01 New Crankshaft Seal Groups Used{1160,1161}
1982/11/01 6V6142 And 6V6143 Installers Can Be Used To Install Crankshaft Seals And Wear Sleeves{0622,0626,1160,1161}
1982/11/01 New Generators{4454,4457,4467}
1982/11/01 New Crankshaft Assemblies{1202,1204,1206,1207,1212}
1982/10/25 Reconditioning Of Oil Pump Covers{1304}
1982/10/25 New Guard Assemblies Used{1360,1381}
1982/10/25 Improvements To Generator-Mounted Control Panels{4450,7400}
1982/11/08 Fabricated Adapter Will Fasten Hydraulic Cylinders To Test Stands{0626,0665,5000}
1982/11/08 Do Not Center-Tap Batteries In 24-Volt System To Operate 12-Volt Accessories{1400,7300}
1982/11/08 Mechanical Shutoff Groups Changed To Prevent Vibration Of Oil Line Tubes{7418}
1982/11/08 High Compression Pistons Can Be Used In Engines Used At High Altitudes{1214}
1982/11/15 Make Change To 6V2100 Multitach And 5P9698 Calibrator{0651}
1982/11/15 Crankshaft Has Step At Front Of No. 1 Main Bearing Journal{1202}
1982/11/15 Repair Kits Available For Air Compressor{1803}
1982/11/22 6V4869 Adapter And 6V6174 Plug Can Be Used To Install Camshaft Bearings{1211,0621}
1982/11/22 Use the 6V6167 Contact Point to Measure Wear Steps on Piston Pins{0653}
1982/11/22 New Seal Used On Governor Control Shaft{1264,1265}
1982/11/22 Service Parts Available For The 5P4150 Nozzle Testing Group{0651,0652}
1982/11/29 Improvements Made To Fuel Ratio Control {1278}