C-15 Petroleum Engine Caterpillar


Turbocharger

Usage:

C-15 Z2C



Illustration 1g01059520

Typical example

(1) V-band clamps

Tighten the V-band clamps to the following torque. ... 14 ± 2 N·m (124 ± 18 lb in)
Gently tap around the V-band clamp with a soft faced hammer. Again tighten the V-band clamps to the following torque. ... 14 ± 2 N·m (124 ± 18 lb in)



Illustration 2g01056787

Typical example

(2) Tighten the studs into the riser assembly to the following torque. ... 35 ± 5 N·m (26 ± 4 lb ft)

Caterpillar Information System:

3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Temperature Sensor - If Equipped
C9 On-Highway Truck Engines Modulating Valve - Remove and Install
Center Steering Arm Straight Bore Inspection and Salvage Procedure for Off-Highway Trucks {4305} Center Steering Arm Straight Bore Inspection and Salvage Procedure for Off-Highway Trucks {4305}
C7 On-Highway Engine Modulating Valve - Remove and Install
C13, C15, and C18 Generator Set Engines Injector Solenoid Circuit - Test
3412E Engine for Caterpillar Built Machines Replacing the ECM
C-10 Petroleum Engine Reference Material
C13, C15, and C18 Generator Set Engines Engine Temperature Sensor Open or Short Circuit - Test
C-10 Petroleum Engine Refill Capacities and Recommendations
3500B and 3500C Marine Engines Fuel Ratio Control
3500B and 3500C Marine Engines Output for the General System Alarm
3412E Engine for Caterpillar Built Machines CID 0190 FMI 08 Engine Speed abnormal
C15 and C18 Petrolem Generator Set Engines Switch Circuits - Test
3412E Petroleum Engine System Configuration Parameters
G3300 Engines Gas Pressure Regulator - Check
C13, C15, and C18 Generator Set Engines Ether Injection System - Test
G3600 Engines Crankshaft Vibration Damper - Inspect
3126B Petroleum Engine Engine Crankcase Pressure (Blowby) - Test
C18 Generator set and C18 Marine Engines Fuel Transfer Pump - Remove
C18 Generator set and C18 Marine Engines Fuel Transfer Pump - Install
3126B Petroleum Engine Belt Tension Chart
G3300 Engines Engine - Clean
G3520C and G3520E Engines Thermostatic Valve
G3600 Engines Cooling System Coolant Level - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.