Vibration Damper - Check
Show/hide table
| |
| 图 1 | g01034223 |
|
典型示例 (1) 齿座 (2) 减振器组件 (3) 皮带轮 (4) 螺栓 | |
减振器安装在曲轴前端。 减振器损坏或减振器故障会增大振动。 这会导致曲轴损坏。
如果出现下列任一情况，应更换减振器：
- 减振器有凹痕、裂纹或液体泄漏。
- 减振器上的油漆因过热而变色。
- 减振器弯曲。
- 螺栓孔磨损或螺栓连接松动。
- 由于扭力造成发动机曲轴故障。
Show/hide table
| 注意 |
|---|
|
检查 粘滞减振器有无渗漏和外壳损坏的迹象。 这两个情况中的任何一个都可能导致重块与外壳相接触。 这种接触会影响减振器的操作。 |
Caterpillar Information System:
C27 and C32 Engines Cooling System - Inspect
C32 Marine Engines Excessive Engine Oil Consumption - Inspect
C27 and C32 Engines Engine Crankcase Pressure (Blowby) - Test
C7 Marine Engine Exhaust Manifold
C27 and C32 Engines Turbocharger - Inspect
C7 Marine Engine Heat Exchanger
2004/04/01 Timing Light Group Helps Adjust Timing for Spark Ignited Engines {0712, 0785}
2004/03/15 New Tool Helps Configure Engine Speed Controller and Adjust Engine Speed Controller {0778, 0781}
2004/02/16 Hydraulically Fractured Connecting Rods are Now In Production for 3054, 3054B, 3054C, 3054E and 3056E Engines {1218}
2004/03/01 Hydraulically Fractured Connecting Rods are Now In Production for 3054, 3054B, 3054C, 3054E and 3056E Engines {1218}
C32 Marine and Marine Generator Set Engines Engine Oil Pressure - Test
C15 On-Highway Engine Compression - Test
C32 Marine Engine Cylinder Head
2004/05/01 Two New Tools Check Tension on Engine Belts {0701, 0767}
Field Installation Procedure for Redundant Electronic Overspeed Protection{1915} Field Installation Procedure for Redundant Electronic Overspeed Protection{1915}
G3500 Engines Diagnostic Code Will Not Clear
G3500 Engines Electronic Service Tool Displays UNDETERMINED
G3500 Engines Electronic Service Tool Will Not Communicate with ECM
G3500 Engines Engine Coolant Temperature (High)
G3500 Engines Engine Coolant Temperature (Low)
G3500 Engines Diagnostic Codes
G3500 Engines Engine Shutdown without a Diagnostic Code
C9 Marine Auxiliary and Marine Generator Set Engines CID 0261 FMI 11 Engine Timing Offset fault
C9 Marine Auxiliary and Marine Generator Set Engines CID 0042 FMI 08 Injector Actuation Valve signal abnormal