CID 0042 FMI 08 Injector Actuation Valve signal abnormal
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the following conditions:
- Battery voltage is above normal and the desired current is greater than 0.2 Amps.
System Response:
The ECM will log the diagnostic code. The ECM attempts to communicate with the Injection Actuation Pressure Control Valve if engine speed is present.
- The engine may misfire and/or shutdown
- The engine may experience reduced speed (rpm) and/or low power.
Test Step 1. Perform the following diagnostic procedure: Injection Actuation Pressure Control Valve Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
C9 Marine Auxiliary and Marine Generator Set Engines CID 0261 FMI 11 Engine Timing Offset fault
G3500 Engines Engine Shutdown without a Diagnostic Code
G3500 Engines Diagnostic Codes
G3500 Engines Engine Coolant Temperature (Low)
G3500 Engines Engine Coolant Temperature (High)
G3500 Engines Electronic Service Tool Will Not Communicate with ECM
G3500 Engines Electronic Service Tool Displays UNDETERMINED
G3500 Engines Diagnostic Code Will Not Clear
Field Installation Procedure for Redundant Electronic Overspeed Protection{1915} Field Installation Procedure for Redundant Electronic Overspeed Protection{1915}
2004/05/01 Two New Tools Check Tension on Engine Belts {0701, 0767}
C32 Marine Engine Cylinder Head
C27 and C32 Engines Vibration Damper - Check
C15 and C18 Industrial Engines Pump Drive - Remove
C15 and C18 Industrial Engines Pump Drive - Install
Cat Commercial Diesel Engine Fluids Recommendations Diesel Engine Antifreeze/Coolant - DEAC
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front) - Remove
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front) - Install
C9 Marine Auxiliary and Marine Generator Set Engines Engine Cranks but Will Not Start
C7 Marine Engine Unit Injector Hydraulic Pump
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Engine Design
C1.5 and C2.2 Engines for Caterpillar Built Marine Generator Sets Cylinder Head
C9 Marine Auxiliary and Marine Generator Set Engines Engine Will Not Crank
2004/02/01 Use the Correct Pin for the Customer Connector {1408}
2005/05/09 A New Oil Pressure Switch is Now Available {7421}