Valve Mechanism Cover Base - Remove and Install
开始:
- 拆卸气门机构盖。 请参阅拆解和组装 , "气门机构盖 - 拆卸和安装" 。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将线束组件从气门机构盖底座上断开。
Show/hide table
图 1 g01045841 - 拆下螺栓 (5)。 将线束组件 (4) 从气门机构盖底座 ( 1)上断开。 拆下接头密封 ( 6)。
- 将线束组件从电子单体喷油器 ( 11) 上断开。
- 拆下螺栓 (10)。 将气门机构盖底座 ( 1) 从缸盖上拆下。
- 将密封 (9) 从气门机构盖底座上拆下。
- 拆下线束组件的螺栓 ( 7) 和卡箍 (8)。
- 拆下线束组件的螺栓 ( 3) 和卡箍 (2)。
- 将线束组件从气门机构盖底座上拆下。
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件说明 | 数量 |
A | 3S-6252 | 密封胶 | - |
B | 9S-3263 | 螺纹锁固胶 | - |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将工具 (B) 涂抹在螺栓 ( 7) 的螺纹上。 拆下线束组件的螺栓 ( 7) 和卡箍 (8)。
- 将工具 (B) 涂抹在螺栓 ( 3) 的螺纹上。 拆下线束组件的螺栓 ( 3) 和卡箍 (2)。
- 将线束组件安装在卡箍 ( 2) 和卡箍 (8) 中,以便将线束组件固定在气门机构盖底座的内侧。
- 将接头密封 (6) 和线束组件 ( 4) 安装在气门机构盖底座上。 安装螺栓 (5)。
注: 安装接头密封时,使密封的弯曲部分紧贴气门机构盖底座。
- 将密封 (9) 安装在气门机构盖底座上。 将工具 (A) 涂抹在密封接头上。
- 将气门机构盖底座 ( 1) 在缸盖上安放到位并安装螺栓 ( 10)。 按照图 3 中显示的数字顺序拧紧螺栓至扭矩为
18 ± 3 N·m (13 ± 2 lb ft) 。 - 将线束组件在电子单体喷油器 ( 11) 上安置到位。 拧紧盖螺母至扭矩为
2.5 ± 0.25 N·m (22 ± 2 lb in) 。 - 将线束组件连接到气门机构盖底座上。
Show/hide table
图 2 | g01045841 |
Show/hide table
图 3 | g00579307 |
拧紧次序 |
结束:
- 安装气门机构盖。 请参阅拆解和组装 , "气门机构盖 - 拆卸和安装" 。
Caterpillar Information System:
C15 and C18 Industrial Engines Valve Mechanism Cover - Remove and Install
G3500 Engines Engine Crankcase Pressure (Blowby) - Test
2004/02/01 Improved Gasket for the Rear Crankshaft Seal Carrier {1161}
2004/02/16 Tool Released for Installing Contact Strips for the Charge Drain within the Flywheel Assembly {0785}
G3500 Engines Engine Speed Sensor - Adjust
C7 Marine Engine Gear Group (Front)
C13, C15, and C18 Generator Set Engines Poor Acceleration or Response
C18 Marine Auxiliary Engines Low Power/Poor or No Response to Throttle
2004/02/16 Tools Ease the Removal and the Installation of Main Bearing Caps {0700, 0705}
C13, C15, and C18 Generator Set Engines Intermittent Low Power or Power Cutout
3116 and 3126 Marine Engines Product Lifting
2004/02/01 Driver Adapter Tool Helps the Technician Service the Spark Plug Adapters {0712}
2004/05/01 Tools Released for the Removal and the Installation of the Camshaft and the Camshaft Bearings {0700, 0701, 0705}
C7 Marine Engine Engine Oil Pan
2004/03/29 Single Element and Multiple Element Filter Heads are Available for Customized Systems {0738}
C-10, C-12, C-15 and C-16 Industrial Engines Excessive White Smoke
2004/04/01 Digital Multimeter Group (Clamp on) Rated at 2000 Amps Available for Electric Power Generation Applications {0709, 0785}
C12 Marine Engines Engine Air Cleaner Service Indicator - Inspect
C12 Marine Engines Engine Crankcase Breather - Clean
G3500 Engines Engine Oil Level Regulator
C7 Marine Engine Flywheel Housing
2004/11/01 Improved Fan Drives are Used {1359}
G3500 Engines Crankcase Breather
C15 and C18 Engines for Caterpillar Built Machines Housing (Front) - Remove