Pistons and Connecting Rods - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 9S-9082 | Engine Turning Tool | 1 |
Start By:
- Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the carbon ridge from the top inside surface of the cylinder liner.
- Use Tooling (A) and turn the crankshaft until two pistons are at the bottom center.
Show/hide table
Illustration 1 g01095957 - Remove bolts (1). Remove bearing caps (2). Push the connecting rods and pistons until the piston rings are out of the cylinder liners.
Note: Be careful not to damage the cylinder liners and/or the crankshaft journals during the removal of the pistons and the connecting rods.
Note: The connecting rods will have numbers on the side with the tab slot of the connecting rod. Numbers are also marked on the bearing caps. The piston and the connecting rod must be installed in the correctly numbered cylinder. Etch the cylinder number in the proper location on a connecting rod and bearing cap if a connecting rod and bearing cap is new.
- Remove the pistons and connecting rods from the cylinder liners.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) EMCP Electronic Control (AC Transformer Box) - Replace
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Electrical Connector - Inspect
Electronic Modular Control Panel II (EMCP II) GSC CID 0268 - FMI 02
2002/05/01 The New 204-8041 Gauge Group Is Available To Measure The Top Ring Groove On Pistons {1214}
Electronic Modular Control Panel II (EMCP II) Display of Voltage or Current is Inaccurate
3126B and 3126E On-highway Engines 0111-03 Coolant Level voltage high (12)
Electronic Modular Control Panel II (EMCP II) Alarm Modules
3412E, C30 and C32 Marine Engines Piston Cooling Jets - Remove and Install
Electronic Modular Control Panel II (EMCP II) Fault Description
3054 and 3056 Marine Generator Set Engines Lubrication System
Electronic Modular Control Panel II (EMCP II) Engine Setpoint Verification OP9
Electronic Modular Control Panel II (EMCP II) Voltmeter/Ammeter Programming OP8
Electronic Modular Control Panel II (EMCP II) EMCP Electronic Control (Generator Set) - Replace
3500 Generator Set Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Install
PMG3516 Power Module Fuel Metering Valve - Check - Raptor
3126B and 3126E On-highway Engines 0111-04 Coolant Level voltage low (12)
C7 and C9 On-Highway Engines Cooling Fan Circuit and A/C High Pressure Switch Circuit - Test
K65-12B Voltage Regulator Dimensions
3054 and 3056 Industrial and Generator Set Engines Engine Oil Filter Base
K65-12B Voltage Regulator Stability - Adjust
3412E, C30 and C32 Marine Engines Pistons and Connecting Rods - Install
3056E Industrial Engine Crankshaft
3412E, C30 and C32 Marine Engines Connecting Rod Bearings - Remove