Carburetor Control Linkage
Show/hide table
Illustration 1 | g01401578 |
Side view (1) Full load position (maximum fuel) |
(A) Angle between vertical and full load position ... 30 degrees
Use the following procedure to install the actuator lever:
- Hold the actuator control shaft in the SHUTOFF position (2) .
- Loosen bolt (8) and rotate the lever (7) to the closed angle (D) that is 40 ± 5 degrees.
- Verify that the lever (7) is the correct distance from the governor. Distance (E) is 4.3 ± 0.5 mm (0.17 ± 0.02 inch).
- Tighten bolt (8) .
Use the following procedure to install the carburetor lever:
- Hold the throttle plate closed.
- Loosen bolt (5) and rotate carburetor lever (4) to closed angle (B) that is 45 degrees.
- Tighten bolt (5) .
Use the following procedure to install the control rod:
- Hold carburetor lever (4) in the SHUTOFF position (2) .
- Adjust carburetor control rod (3) until the rod fits between lever (7) and carburetor lever (4) .
- Ensure that there is no binding during full travel of the control linkage.
- Torque the jam nut (6) to 13 ± 3 N·m (115 ± 27 lb in).
(C) Approximate length of the carburetor control rod. ... 518 mm (20.4 inch)
Caterpillar Information System:
3056E Industrial Engine Crankshaft Seals
3056E Industrial Engine Water Temperature Regulator
3056E Industrial Engine Engine Oil Pan
3054E Industrial Engine Engine Oil Pressure
3056E Industrial Engine Engine Oil Pump
G3408C and G3412C Engines Carburetor Control Linkage
3056E Industrial Engine Cylinder Head Valves
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 08
3056E Industrial Engine Fuel Injection Nozzles
3500 Engines Duplex Oil Filter - Adjust
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02
G3612 and G3616 Engines Turbocharger - Assemble
2002/04/01 Change to Specifications Manual {1157}
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
G3408C and G3412C Engines Carburetor Control Linkage
Inadvertent Rollover of Lifetime Totals{1901} Inadvertent Rollover of Lifetime Totals{1901}
C-9 Industrial Engine Glossary of Electronic Control Terms
2002/04/01 Jacket Water Tank Type Heaters Are Now Available {1383}
C-9 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
3412 Generator Set Engines Gear Group (Front)
G3304 and G3306 Engines Coolant Temperature Switch