Carburetor Control Linkage
Show/hide table
Illustration 1 | g01514418 |
Side view (2) Full load position (maximum fuel) |
(1) Torque for two taperlock studs ... 17 ± 5 N·m (150 ± 45 lb in)
Show/hide table
Illustration 2 | g01514419 |
Top view |
(B) Angle between perpendicular and full load position ... 35 degrees
Use the following procedure to install the actuator lever:
- Hold the actuator control shaft in the SHUTOFF position (5) .
- Loosen bolt (7) and rotate the lever (6) to the closed angle (A) that is 20 + 10 - 0 degrees.
- Tighten bolt (7) .
Use the following procedure to install the carburetor lever:
- Hold the throttle plate closed.
- Loosen bolt (8) and rotate carburetor lever (9) to closed angle (C) that is 40 degrees.
- Tighten bolt (8) .
Use the following procedure to install the carburetor control rod:
- Hold lever (6) in the SHUTOFF position (5) .
- Adjust carburetor control rod (3) until the rod fits between carburetor lever (9) and lever (6) .
- Ensure that there is no binding during full travel of the control linkage.
- Torque the jam nuts (4) to 13 ± 3 N·m (115 ± 27 lb in).
Caterpillar Information System:
3056E Industrial Engine Cylinder Head Valves
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 08
3056E Industrial Engine Fuel Injection Nozzles
3500 Engines Duplex Oil Filter - Adjust
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0672 - FMI 02
G3612 and G3616 Engines Turbocharger - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Camshaft
G3612 and G3616 Engines Turbocharger - Disassemble
2002/04/01 Marine Transmission Oil Pressure Sensor Location {3323}
3056E Industrial Engine Inlet Manifold
3500 Generator Set Engines Pressure Switch
3500 Generator Set Engines Pressure Switch
3056E Industrial Engine Engine Oil Pump
3054E Industrial Engine Engine Oil Pressure
3056E Industrial Engine Engine Oil Pan
3056E Industrial Engine Water Temperature Regulator
3056E Industrial Engine Crankshaft Seals
G3408C and G3412C Engines Carburetor Control Linkage
2002/04/01 Change to Specifications Manual {1157}
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
3500 Generator Set Engines Cooling System Pressure Cap
G3408C and G3412C Engines Carburetor Control Linkage