Swivel - Assemble
Assembly Procedure
- Make sure that all of the parts of the swivel joint are thoroughly clean and free of dirt and debris.
- Check the condition of seals (3) and O-ring seals (6). If the seals or O-ring seals are worn or damaged, use new parts for replacement.
Show/hide table
Illustration 1 | g00360892 |
- Install seals (3) and O-ring seals (6) in outside housing (8). Apply 5P-0960 Molybdenum Grease on seals (3) and O-ring seals (6) .
- Install outside housing (8) over rotor (9). Install retainer (7), two bolts (5) and the washers that hold the retainer.
- Check the condition of O-ring seal (4). If the O-ring seal is worn or damaged, use new parts for replacement.
- Apply 5P-0960 Molybdenum Grease on O-ring seal (4). Install the O-ring seal in the outside housing.
- Install cover (2) and four bolts (1) that hold the cover.
- Check the swivel joint for leaks. Plug the drain ports of the inside body. Apply shop air pressure in the top of the swivel joint to check for leaks.
End By: Install the swivel joint. Refer to Disassembly and Assembly, "Swivel - Install" in this manual.
Caterpillar Information System:
3054 and 3056 Marine Generator Set Engines Water Pump - Remove - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Disassemble
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Install
3054 and 3056 Marine Generator Set Engines Engine Oil Cooler - Remove and Install - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Remove
Electronic Modular Control Panel II (EMCP II) Charging System
Electronic Modular Control Panel II (EMCP II) SP Fault Code
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Remove - 3056 Engine
3126 Truck Engine Military Inlet Manifold - Install
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Install - 3054 Engine
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Remove - 3054 Engine
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
3054 and 3056 Industrial and Generator Set Engines Water Pump - Inspect
3054 and 3056 Marine Generator Set Engines Water Pump - Install - 3054 Engine
2014/02/07 The 127-2450 Cylinder Head Kit Includes A New Cylinder Head Group {1100}
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for EUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3056 Engine
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Install - 3056 Engine
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for MUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3054 Engine
2002/06/01 A New Valve Adjusting Screw Is Available {1123}
Electronic Modular Control Panel II (EMCP II) Indicator for High Water Temperature
Electronic Modular Control Panel II (EMCP II) Indicator for Low Oil Pressure