Swivel - Disassemble
Disassembly Procedure
Start By:
- Remove the swivel joint. Refer to Disassembly and Assembly, "Swivel - Remove" in this manual.
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Make sure that the outside of the swivel joint is thoroughly clean prior to disassembly.
- Remove four bolts (1) and remove cover (2) from outside housing (8). Remove O-ring seal (4) from outside housing (8) .
Show/hide table
Illustration 1 | g00360892 |
- Remove two bolts (5), the washers and retainer (7) from rotor (9). Remove outside housing (8) from the rotor (9) .
- Turn the outside housing upside-down and remove O-ring seal (6) and seals (3) from the outside housing.
Caterpillar Information System:
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Install
3054 and 3056 Marine Generator Set Engines Engine Oil Cooler - Remove and Install - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Remove
Electronic Modular Control Panel II (EMCP II) Charging System
Electronic Modular Control Panel II (EMCP II) SP Fault Code
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Install - 3056 Engine
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Remove - 3056 Engine
3126 Truck Engine Military Inlet Manifold - Install
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Install - 3054 Engine
3054 and 3056 Marine Generator Set Engines Engine Oil Filter Base - Remove - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swing Gear and Bearing - Install
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swing Gear and Bearing - Remove
3054 and 3056 Marine Generator Set Engines Water Pump - Remove - 3054 Engine
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Swivel - Assemble
Electronic Modular Control Panel II (EMCP II) Pulse Width Modulated Sensor
3054 and 3056 Industrial and Generator Set Engines Water Pump - Inspect
3054 and 3056 Marine Generator Set Engines Water Pump - Install - 3054 Engine
2014/02/07 The 127-2450 Cylinder Head Kit Includes A New Cylinder Head Group {1100}
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for EUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3056 Engine
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Install - 3056 Engine
Electronic Modular Control Panel II (EMCP II) Indicator for Emergency Stop (for MUI Engines)
3054 and 3056 Marine Generator Set Engines Heat Exchanger - Remove - 3054 Engine
2002/06/01 A New Valve Adjusting Screw Is Available {1123}