Power Module Switchgear (Low Voltage and Medium Voltage) Caterpillar


Burn Prevention

Usage:

PM3508 BLM

Coolant

At operating temperature, the engine coolant is hot and the engine coolant is under pressure. The radiator and all lines to heaters or to the engine contain hot coolant or steam. Any contact can cause severe burns.

Steam can cause personal injury.

Only check the coolant level after the engine has been stopped. Make sure that the radiator cap is cool. In order to remove the radiator cap with the bare hand, the radiator cap must be cool. In order to relieve pressure, remove the radiator cap slowly.

Cooling system conditioner contains alkali. Alkali can cause personal injury. Do not allow alkali to contact the skin, the eyes or the mouth.

Allow cooling system components to cool before draining.

Oils

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.

Remove the cap for the makeup tank after the engine has stopped. The filler cap must be cool to the touch.

Relieve all of the pressure in any system (air systems, oil systems, fuel systems, or cooling systems) before any system components are disconnected.

Batteries

Batteries give off flammable fumes which can explode.

Do not smoke when observing the battery electrolyte levels.

The liquid in a battery is an electrolyte. Electrolyte is an acid. Electrolyte can cause personal injury. Do not allow electrolyte to contact the skin or the eyes.

Always wear protective glasses when you work with batteries.

Caterpillar Information System:

Power Module Switchgear (Low Voltage and Medium Voltage) Engine Stopping
Power Module Switchgear (Low Voltage and Medium Voltage) Engine Starting
Power Module Switchgear (Low Voltage and Medium Voltage) Before Starting Engine
3114, 3116, and 3126 Industrial and Generator Set Engines Fan Drive Bearing - Lubricate - If Equipped
3056E Industrial Engine Camshaft Bearings
Automatic Transfer Switches CTG, CTGD Series Power Failure Operation
PMG3516 Power Module Reference Material
Automatic Transfer Switches CTG, CTGD Series Control Connections of the Transfer Switch
3512B and 3516B High Displacement Locomotive Engines Specifications
G3500B Engines Fumes Disposal Filter Element - Replace
G3500 Generator Sets Fumes Disposal Filter - Drain
G3612 and G3616 Engines Crankcase Pressure - Measure - Engines with Fumes Disposal Filters
Operating Instructions for the 4P-4788 Electrical Converter Gp and the 4P-4789 Electrical Converter Gp {1421} Operating Instructions for the 4P-4788 Electrical Converter Gp and the 4P-4789 Electrical Converter Gp {1421}
2001/10/01 New Piston Assemblies Are Used {1214}
G3408C and G3412C Engines Ignition Transformer
SR4 Generator with VR3 or VR4 Voltage Regulator Glossary
Installation and Removal Of The Mechanically Attached Wear Plate System Installation and Removal Of The Mechanically Attached Wear Plate System
SR4 Generator with VR3 or VR4 Voltage Regulator General Information
3406E and C15 Marine Engines Auxiliary Water Pump - Disassemble - Rubber Impeller
C27 and C32 Engines for Caterpillar Built Machines CID 1589 FMI 03 Turbo Inlet Air Pressure Sensor open/shrt to +bat
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Pressure Switch - Remove and Install
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Glow Plugs - Remove and Install
3126B Marine Engines CID 0105 FMI 03 Inlet Manifold Temp Sensor open/short to +batt
Automatic Transfer Switches CTG, CTGD Series Exerciser
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.