3114, 3116, and 3126 Industrial and Generator Set Engines Caterpillar


Fan Drive Bearing - Lubricate - If Equipped

Usage:

3116 1NJ


Illustration 1g00123252
Typical grease fitting for the fan drive bearing

Lubricate the fan drive bearing with Bearing Lubricant Special Purpose Grease or the equivalent.

Inspect the fan drive pulley assembly. If the shaft is loose, an inspection of the internal components should be performed. Refer to the Service Manual.

Caterpillar Information System:

3056E Industrial Engine Camshaft Bearings
Automatic Transfer Switches CTG, CTGD Series Power Failure Operation
PMG3516 Power Module Reference Material
Automatic Transfer Switches CTG, CTGD Series Control Connections of the Transfer Switch
3512B and 3516B High Displacement Locomotive Engines Specifications
G3500B Engines Fumes Disposal Filter Element - Replace
G3500 Generator Sets Fumes Disposal Filter - Drain
G3612 and G3616 Engines Crankcase Pressure - Measure - Engines with Fumes Disposal Filters
G3500B Engines Fumes Disposal Filter Differential Pressure - Check
2001/10/01 Parts Manuals for Skid Mounted Pumpers and Skid Mounted Power Packs Are Now Provided on CD-ROMs {7000}
PMG3516 Power Module Engine Crankcase Breather - Clean
Automatic Transfer Switches CTG, CTGD Series General Information
Power Module Switchgear (Low Voltage and Medium Voltage) Before Starting Engine
Power Module Switchgear (Low Voltage and Medium Voltage) Engine Starting
Power Module Switchgear (Low Voltage and Medium Voltage) Engine Stopping
Power Module Switchgear (Low Voltage and Medium Voltage) Burn Prevention
Operating Instructions for the 4P-4788 Electrical Converter Gp and the 4P-4789 Electrical Converter Gp {1421} Operating Instructions for the 4P-4788 Electrical Converter Gp and the 4P-4789 Electrical Converter Gp {1421}
2001/10/01 New Piston Assemblies Are Used {1214}
G3408C and G3412C Engines Ignition Transformer
SR4 Generator with VR3 or VR4 Voltage Regulator Glossary
Installation and Removal Of The Mechanically Attached Wear Plate System Installation and Removal Of The Mechanically Attached Wear Plate System
SR4 Generator with VR3 or VR4 Voltage Regulator General Information
3406E and C15 Marine Engines Auxiliary Water Pump - Disassemble - Rubber Impeller
C27 and C32 Engines for Caterpillar Built Machines CID 1589 FMI 03 Turbo Inlet Air Pressure Sensor open/shrt to +bat
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.