Heat Exchanger - Disassemble - 3054 and 3054B Engines
Disassembly Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Put a mark (1) on end cap (3) and on the body of the heat exchanger. The mark will identify the proper position of the end cap for reassembly.
Show/hide table
 | |
| Illustration 1 | g00744051 |
Typical example | |
- Remove six bolts (2) from end cap (3) .
- Remove end cap (3) from the heat exchanger.
- Repeat Steps 1 through 3 in order to remove the end cap on the reverse end.
- Remove tube bundle (5) from the body of heat exchanger (4) .
Show/hide table
 | |
| Illustration 2 | g00744076 |
Typical example | |
- Discard the O-ring seals from both end caps.
Caterpillar Information System:
3054, 3054B and 3056 Marine Engines Heat Exchanger - Install - 3054 and 3054B Engines
797 Off-Highway Truck Power Train Final Drive - Assemble
Electronic Modular Control Panel II (EMCP II) GSC CID 0441 - FMI 12 (for MUI Engines)
3034 Marine Engine Fuel System Secondary Filter - Replace
3054, 3054B and 3056 Marine Engines Heat Exchanger - Remove - 3054 and 3054B Engines
Electronic Modular Control Panel II+ (EMCP II+) Starting Motor Magnetic Switch - Test
3512B Marine Auxiliary Engine System Overview
G3520C and G3520E Engines Water Temperature Regulator
120H and 135H Motor Graders Alternate Exit
G3600 Engines Engine Speed/Timing Sensor - Clean/Inspect
3054 and 3056 Industrial and Generator Set Engines Fuel System - Prime
3034 Marine Engine - Installation Guide Engine Mounting
3054, 3054B and 3056 Marine Engines Heat Exchanger - Assemble - 3054 and 3054B Engines
2001/07/01 New Hydrax Electronic Control Is Available {1900}
EMCPII+ for Gas Engines Starting Motor Magnetic Switch - Test - 3500 Engines Only
2001/06/01 Change to the Torque of the Adjusting Screw Locknut for the Unit Injector (Specifications Manuals) {1290}
2001/06/01 Change to the Torque of the Adjusting Screw Locknut for the Unit Injector (Testing and Adjusting Manuals) {1290}
Electronic Modular Control Panel II+ (EMCP II+) Shutdown Mode - PEEC and EUI Engines
Electronic Modular Control Panel II+ (EMCP II+) Shutdown Mode - MUI Engines
3034 Marine Engine Basic Engine
3500B and 3500B High Displacement Generator Set Engines Electronic Display Module
3034 Marine Engine General Information
G3600 Engines Air Lines - Air Choke with VTC Turbocharger
3034 Marine Engine Cooling System