Fuel Injection Nozzles - Install - 3013, 3014 and 3024 Engines
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install gasket (5) into the injector bore in the cylinder head.
Show/hide table
Illustration 1 | g00624882 |
Note: Do not reuse gasket (5) after disassembly. Replace the gasket with a new part before installation.
- Install fuel injection nozzle (3) into the cylinder head. Tighten the fuel injection nozzles to a torque of 64 N·m (47 lb ft).
- Inspect copper gaskets (4) that are for the fuel return line at the injectors. If the copper gaskets are worn or damaged, use new parts for replacement. Install copper gasket (4) on each fuel injection nozzle (3) .
- Install fuel return line (2) and nuts (1) on each fuel injection nozzle (3). Tighten each nut (1) to a torque of 20 N·m (15 lb ft).
Show/hide table
Illustration 2 | g00624878 |
End By: Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Caterpillar Information System:
3508, 3512, and 3516 Generator Sets Product Description
3508, 3512, and 3516 Generator Sets Model View Illustrations
2001/02/01 Complete Engine Control Panels For 3600 Diesel Engines Will Not Be Serviced At The Upper Group Level {7490}
G3516B and G3520B Generator Set Engines Carburetor - Install
330D, 336D, 336D2, 340D and 340D2 Excavators Machine System Specifications Accumulator (Pilot)
2001/01/01 Improvements to Caterpillar's Gasket Kits for Engines {7555}
3500B Generator Sets Manual Stop Procedure
2001/01/01 Improvements to Caterpillar's Gasket Kits for Engines {7555}
3126B and 3126E On-highway Engines Ignore Brake/Clutch Switch Circuit - Test
G3516B and G3520B Generator Set Engines Carburetor - Remove
2001/01/01 New Exhaust Sleeve Assembly {1059}
3512B HD SR500 Generator Sets After Stopping Engine
PM3500 Power Modules Specifications
G3516B and G3520B Generator Set Engines Exhaust Elbow - Remove and Install
G3612 and G3616 Engines Welding on Engines with Electronic Controls
3126B and 3126E On-highway Engines Neutral Switch Circuit - Test
3500 Generator Sets Speed Sensor - Clean/Inspect
3500 Generator Set Engines Turbocharger
C-9 Industrial Engine Cylinder Head Grounding Stud - Inspect/Clean/Tighten
330C Excavator Engine Crankcase Breather - Clean
3524B Engines for 797 and 797B Off-Highway Trucks Cylinder Heads
3126B and 3126E Truck Engine Air Inlet and Exhaust System - Inspect
HT400 Pumper Belt - Inspect
3500 Generator Set Engines Engine Oil Pressure - Test