Fuel Control Valve - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn off the gas supply.
Show/hide table
Illustration 1 g00764979 - Remove bolts (1) from the flange and tubes on each side of fuel control valve (2).
- Disconnect electrical connection (2) from fuel control valve (2).
Show/hide table
Illustration 2 g00764988 - Remove four bolts (4) that fasten fuel control valve (2) to the mounting plate. Remove fuel control valve (2).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position the fuel control valve (2) on the mounting plate and install four bolts (4).
Show/hide table
Illustration 4 g00764999 - Install gasket (5) on each end of fuel control valve (2).
Show/hide table
Illustration 5 g00764979 - Put the flange and tubes in position and install bolts (3).
- Install electrical connection (3) on the fuel control valve (2).
- Turn on the gas supply.
Show/hide table
Illustration 3 | g00764988 |
Caterpillar Information System:
3126B Petroleum Engine Engine Cranks but Will Not Start
2001/01/15 Improvements to Caterpillar's Gasket Kits for Engines {7555}
3054, 3054B and 3056 Marine Engines Air Inlet Heater - Test
3054 Engine Cylinder Block - Inspect
2001/02/01 A New Fuel Transfer Pump is Now Available for 3054 Engines {1256}
3126B Industrial Engines Intermittent Low Power or Power Cutout
3406E and 3456 Generator Set Engines General Information
3516B and 3516B HD Engines and 994D, 994F, and 994H Wheel Loaders Turbocharger
3126B Industrial Engines Intermittent Engine Shutdown
3054, 3054B and 3056 Marine Engines Piston and Rings
3054 Engine Piston Height - Inspect
2000/12/01 A New ADEM 2000 ECM is Now Available {1901}
3126B Industrial Engines Flash Codes
3054, 3054B and 3056 Marine Engines Automatic Timing Advance Unit - Test
TA19-M2WD and TA19-M4WD (Delta) Agricultural Transmission Power Train Electronic Control System Switch Circuits
C-15 and C-16 Industrial Engines Electronic Control System Components
3054 Engine Electric Starting System - Test
Marine Monitoring System II Remote Operation
C-15 and C-16 Industrial Engines Electronics Grounding Stud - Inspect/Clean/Tighten
Marine Monitoring System II Feature Configuration
3500 Marine Engines Camshaft
3054 and 3056 Marine Generator Set Engines Engine Vibration Troubleshooting
3406E and 3456 Industrial Engines Water Pump - Test
3500B Industrial Engines System Configuration Parameters