Metal Particle Detector - Inspect
If the metal particle detector causes a shutdown, inspect the detector.
Show/hide table
Illustration 1 | g00745503 |
Metal particle detector (1) Cover |
- Use a 1/2 inch ratchet to remove cover (1) and the O-ring seal from the detector.
- Remove the grid and the O-ring seal for the grid from the inside of the detector.
- If metal particles are found, determine the source of the particles. Make repairs, as needed.
- Clean the inside of the detector and clean the grid with nonflammable solvent.
Show/hide table
NOTICE |
---|
Metal particles in the lube oil may indicate a serious condition that requires immediate attention. If metal particles are found in the grid of the detector, do not start the engine until the source of the particles is found and the condition is corrected. Failure to do so could cause severe damage to the engine. |
- Inspect the grid and the O-ring seals for good condition. Obtain new parts, if necessary.
Note: To replace the O-ring seals and the grid, use the 165-5690 Particle Detector Kit .
- Install the clean, dry grid and the O-ring seal for the grid.
- Install the cover and the O-ring seal for the cover. Torque the cover to 54 N·m (40 lb ft).
Caterpillar Information System:
2000/10/01 A New Cylinder Liner And A New Combustion Gasket Are Used {1216, 7555}
3054, 3054B and 3056 Marine Engines Air Cleaner - Remove and Install
3500B Industrial Engines Electrical Connectors and Functions
2000/11/01 New Turbochargers Are Now Available {1052}
3618 Engine Oil Mist Detector - Maintain
3116 On Highway Engines Pistons and Connecting Rods - Remove
3116 On Highway Engines Pistons and Connecting Rods - Disassemble
3054, 3054B and 3056 Marine Engines Water Temperature Regulator Housing - Remove and Install - 3056 Engine
3608 Engine Plate Locations and Film Locations
3618 Engine Specifications
2000/10/01 New Jake Brake Housing {1119, 1129}
Electronic Modular Control Panel II (EMCP II) Starting Motor Magnetic Switch - Test - PEEC Engines Only
3406E On-Highway Engine Crankshaft Rear Seal - Install
3406E Engine Engine Control Module - Remove and Install
3054, 3054B and 3056 Marine Engines Crankcase Breather - Remove and Install - 3056 Engine
3500B Industrial Engines Injector Solenoids
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Static Switch Module - Remove and Install
3500B Industrial Engines Prelubrication System
2000/10/01 A New Fuel Filter Element Assembly Has Been Released {1261}
G3406 Engines Cylinder Head Valves
2001/01/01 Watch Windows Standard Software Is Now Available {7620}
3618 Engine Hourly Performance Log
3618 Engine Daily Performance Log
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel System - Prime