Water Temperature Regulator - Test
- Heat water in a pan until the temperature is 91 °C (195 °F). Stir the water in the pan. This will distribute the temperature throughout the pan.
- Hang the water temperature regulator in the pan of water.
The water temperature regulator must be below the surface of the water. The water temperature regulator must be away from the sides and the bottom of the pan.
- Keep the water at the correct temperature for ten minutes.
- After ten minutes, remove the water temperature regulator. Measure the opening of the water temperature regulator immediately after the water temperature regulator is removed from the water. The distance must be a minimum of 9.5 mm (0.37 inch).
- If the distance is less than 9.5 mm (0.37 inch), replace the water temperature regulator.
Caterpillar Information System:
EMCPII+ for Gas Engines GSC CID 0110 - FMI 04
G3516B Engines PWM Sensor
3306C Truck Engine Cooling System - Test
3306C Truck Engine Cooling System - Inspect
3306C Truck Engine Cooling System - Check
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Parameters - Program
3306C Truck Engine Electric Starting System - Test
2000/07/01 The Use Of The 179-1502 Oil Filter Element Will Extend Oil Change Intervals For G3600 Engines {1308}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0446 - FMI 12
3306C Truck Engine Charging System - Test
3306C Truck Engine Battery - Test
Electronic Modular Control Panel II+ (EMCP II+) Troubleshooting Diagnostic Codes
3500B Engines for Caterpillar Built Power Modules Shutdown Notification Output
3306C Truck Engine Excessive Engine Oil Consumption - Inspect
C7 Engines for Caterpillar Built Machines Excessive Bearing Wear - Inspect
3306C Truck Engine Increased Engine Oil Temperature - Inspect
3500B and 3500B High Displacement Generator Set Engines Configuration Parameters
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Configurations - Test
EMCPII+ for Gas Engines GSC CID 0175 - FMI 02
Alternator - Delco 21SI Insulated Screw - Check
2000/07/01 Correction to The Pocket Guide, SEBD0402 Is Available as a Reference for Routing and Installing Wire Harness Assemblies {1408}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0447 - FMI 12 (for EUI Engines)
JF Series Starting Motor Starting Motor - Assemble
G3516B Engines Oxygen Sensor - Calibrate