Shutdown Notification Output
This system provides an indication when the engine control is shutting down the engine. The relay provides a common ground, a normally open contact, and a normally closed contact. The relay will be energized after the crank terminate speed has been attained. The relay will be de-energized if any of the following conditions occur:
- The engine is shut down by the programmable engine monitoring system.
- The remote emergency stop switch is activated.
- The Customer Communication Module (CCM) has requested a normal shutdown.
- The CCM has requested an emergency stop shutdown.
- The engine is shut down by the overspeed verify feature.
- The engine is in the stop or the off state.
- The personality module interlock occurs.
- The speed drops below the crank terminate speed.
Use of this relay is a function of the installation.
Caterpillar Information System:
3306C Truck Engine Water Temperature Regulator - Test
EMCPII+ for Gas Engines GSC CID 0110 - FMI 04
G3516B Engines PWM Sensor
3306C Truck Engine Cooling System - Test
3306C Truck Engine Cooling System - Inspect
3306C Truck Engine Cooling System - Check
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Parameters - Program
3306C Truck Engine Electric Starting System - Test
2000/07/01 The Use Of The 179-1502 Oil Filter Element Will Extend Oil Change Intervals For G3600 Engines {1308}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0446 - FMI 12
3306C Truck Engine Charging System - Test
3306C Truck Engine Battery - Test
3306C Truck Engine Excessive Engine Oil Consumption - Inspect
C7 Engines for Caterpillar Built Machines Excessive Bearing Wear - Inspect
3306C Truck Engine Increased Engine Oil Temperature - Inspect
3500B and 3500B High Displacement Generator Set Engines Configuration Parameters
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Configurations - Test
EMCPII+ for Gas Engines GSC CID 0175 - FMI 02
Alternator - Delco 21SI Insulated Screw - Check
2000/07/01 Correction to The Pocket Guide, SEBD0402 Is Available as a Reference for Routing and Installing Wire Harness Assemblies {1408}
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0447 - FMI 12 (for EUI Engines)
JF Series Starting Motor Starting Motor - Assemble
G3516B Engines Oxygen Sensor - Calibrate
Alternator - Delco 21SI Rectifier - Test