| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | FT-2674(1) | Vacuum Cap | 1 |
| (1) | Add a |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure- Release".
Note: Put identification marks on all hose assemblies for installation purposes. Plug all of the hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Clean the swing motor, and clean the area around the swing motor prior to removing the swing motor.
Show/hide table
Illustration 1 g01589881 - Open engine hood (1). Open housing (2) for the refrigerant condenser.
Show/hide table
Illustration 2 g01593299 - Disconnect harness assembly (4) from refrigerant condenser (3). Disconnect clip (5).
Show/hide table
Illustration 3 g01593305 - Remove panel (6).
Show/hide table
Illustration 4 g01593307 Show/hide table
Illustration 5 g01593133 - Remove top mounting bolts (7). Repeat for the three bottom mounting bolts.
- Disconnect clips (9) and (11). Remove bolts (10). Reposition refrigerant dryer (8) and the refrigerant condenser as a unit.
Show/hide table
Illustration 6 g01593353 - Remove panel (12).
Show/hide table
Illustration 7 g01593354 - Remove panel (13).
Show/hide table
Illustration 8 g01593357 - Open storage box (14) for the window guards.
Show/hide table
Illustration 9 g01571093 - Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply
276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.Show/hide table
Illustration 10 g01593355 - Remove all hose assemblies (15) from the swing motor.
Show/hide table
Illustration 11 g01593356 - Attach a suitable lifting device to swing motor (16). The weight of swing motor (16) is approximately
43 kg (94 lb) . - Remove bolts (17). Remove swing motor (16).
