Pilot Valve (Boom Swing) - Assemble
- Install O-ring seals (5), coil (7), nut (8), and nut (9) onto cartridge (6).
Show/hide table
Illustration 2 g01227495 - Install solenoids (2), bolts (1), the O-ring seal, and plug (4) onto block (3).
Show/hide table
Illustration 1 | g01227496 |
End By:
- Install the pilot valve. Refer to Disassembly and Assembly, "Pilot Valve (Boom Swing) - Install".
Caterpillar Information System:
303.5C and 303C Mini Hydraulic Excavators Machine Systems Pilot Valve (Boom Swing) - Disassemble
2006/01/30 Improved Air Conditioning Circulation on Excavator {7251, 7276}
2006/04/24 A Conical Bumper Has Been Added for the Alignment of the Rear Hood on Mini Hydraulic Excavators {1051, 7251}
Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264} Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264}
2006/02/13 Disposable Dessicant Filter is Now Available {0618, 0646}
2006/01/23 Proper Identification of Ports on 5P-0306 Vacuum Transducer {0768, 5050, 5056}
C11 and C13 Engines Engine Oil Pressure Sensor
2006/01/30 Installation Instructions for the Grease Fittings on Hydraulic Hammers {6333}
320D and 323D Excavators Machine System Specifications Stick Cylinder
320D and 323D Excavators Machine System Specifications Boom Cylinder
Fast Fill System-Fuel {1273, 1279, 1710} Fast Fill System-Fuel {1273, 1279, 1710}
C27 and C32 Engines for Caterpillar Built Machines CID 1785 FMI 10 Intake Manifold Pressure Signal abnormal rate of change
Installation of the 225-4256 Film {7405, 7557} Installation of the 225-4256 Film {7405, 7557}
C15 Engine for the 657G Wheel Tractor-Scraper Event Codes
2006/03/27 Relocation of the Quick Disconnect Connector's on the Excavator Stick {1329, 5057}
2006/01/30 Installation Procedure for Accumulators on Mini Hydraulic Excavators {5077}
330D and 336D Excavators Machine System Specifications Main Hydraulic Pump
325D and 329D Excavators Quick Coupler Operation - Hydraulic Pin Grabber Quick Coupler (If Equipped)
M325D and M330D Excavators Power Train Electronic Control System Connector Contact Description
2006/06/05 The Stick and Bucket Cylinders are Improved on Mini Hydraulic Excavators {5457, 5458}
2006/03/20 A New Exhaust Gasket Is Now Available {1059}
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Refrigerant Compressor
Salvage of Tapered Steering Bores {4301, 4305, 4310} Salvage of Tapered Steering Bores {4301, 4305, 4310}
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Sensors and Electrical Connectors