Connector Contact Description
下表显示 ECM 接头 J1 和 J2 的触点分配。
Show/hide table
| ECM 接头的触点描述 | |
|---|---|
| 1 | 功能 |
| J1-1 | 钥匙开关接通 |
| J1-10 | CDL + |
| J1-11 | 变速箱压力传感器 - 信号 |
| J1-13 | 蓄电池 - |
| J1-20 | CDL - |
| J1-21 | 变速箱离合器压力传感器低压回路 |
| J1-23 | 蓄电池 - |
| J1-31 | 蓄电池 + |
| J1-33 | 制动器油蓄能器压力开关 |
| J1-34 | 真空膜盒滤清器堵塞开关 |
| J1-37 | 行驶踏板位置传感器 - 信号 |
| J1-38 | 蓄电池 + |
| J1-39 | 蓄电池 + |
| J1-40 | 行车制动器压力开关 |
| J1-41 | 油水分离器开关 |
| J1-42 | 空气滤清器堵塞开关 |
| J1-43 | 回转微调开关 |
| J1-45 | 蓄电池 + |
| J1-47 | 蓄电池 + |
| J1-48 | 行驶马达旋转斜盘角度限制电磁阀 |
| J1-49 | 行驶先导压力电磁阀 |
| J1-50 | 回路 - 行驶马达旋转斜盘角度电磁阀、行驶先导压力电磁阀 |
| J1-56 | 行驶踏板位置传感器回路 |
| J1-57 | 蓄电池 - |
| J1-59 | 机具锁定电磁阀 |
| J1-60 | 回路 - 机具锁定、摆动轴电磁阀 |
| J1-61 | 摆动轴电磁阀 |
| J2-1 | 钥匙开关起动 |
| J2-2 | 行驶警报 |
| J2-4 | 回路 - 行驶警报、起动马达继电器回路 |
| J2-5 | 变速箱换档电磁阀 1 |
| J2-6 | 变速箱换档电磁阀 2 |
| J2-7 | 起动继电器 |
| J2-8 | 回路 - 变速箱换档电磁阀 1 和电磁阀 2 |
| J2-9 | 回路 - MH 锁定继电器 |
| J2-23 | 扶手位置开关 (NO) |
| J2-24 | 变速箱输出转速传感器 |
| J2-28 | 扶手位置开关 (NC) |
| J2-30 | 行车制动器踏板限位开关锁定 (NO) |
| J2-31 | 行车制动器踏板限位开关锁定 (NC) |
| J2-63 | 回路 - 制动器油附件压力开关、行车制动器限位开关 |
| J2-67 | CAN + |
| J2-68 | CAN- |
Caterpillar Information System:
325D and 329D Excavators Quick Coupler Operation - Hydraulic Pin Grabber Quick Coupler (If Equipped)
330D and 336D Excavators Machine System Specifications Main Hydraulic Pump
2006/01/30 Installation Procedure for Accumulators on Mini Hydraulic Excavators {5077}
2006/03/27 Relocation of the Quick Disconnect Connector's on the Excavator Stick {1329, 5057}
C15 Engine for the 657G Wheel Tractor-Scraper Event Codes
Installation of the 225-4256 Film {7405, 7557} Installation of the 225-4256 Film {7405, 7557}
303.5C and 303C Mini Hydraulic Excavators Machine Systems Pilot Valve (Boom Swing) - Assemble
303.5C and 303C Mini Hydraulic Excavators Machine Systems Pilot Valve (Boom Swing) - Disassemble
2006/01/30 Improved Air Conditioning Circulation on Excavator {7251, 7276}
2006/04/24 A Conical Bumper Has Been Added for the Alignment of the Rear Hood on Mini Hydraulic Excavators {1051, 7251}
Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264} Squeal which is Caused by the Pressure Relief Valve on 301.6C, 301.8C and 302.5C Mini Hydraulic Excavators{5057, 5264}
2006/02/13 Disposable Dessicant Filter is Now Available {0618, 0646}
2006/06/05 The Stick and Bucket Cylinders are Improved on Mini Hydraulic Excavators {5457, 5458}
2006/03/20 A New Exhaust Gasket Is Now Available {1059}
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Refrigerant Compressor
Salvage of Tapered Steering Bores {4301, 4305, 4310} Salvage of Tapered Steering Bores {4301, 4305, 4310}
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Sensors and Electrical Connectors
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders System Configuration Parameters
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Event Codes
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders E360 Low Engine Oil Pressure
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Alternator - Charging Problem and/or Noisy Operation
319D Excavator Hydraulic Tank Screen - Clean
C6.6 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C6.6 Engines for Caterpillar Built Machines Fuel Pressure Sensor