| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 1U-9744 | Hydraulic Jack | 1 |
Start By:
- Remove the travel motor. Refer to Disassembly and Assembly, "Travel Motor - Remove".
- Remove the rear tires and rims. Refer to Disassembly and Assembly, "Tire and Rim - Remove".
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Drain the oil from the rear axle into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Axle Oil (Rear) - Change".
Show/hide table
Illustration 1 g01175091 - Disconnect hose assemblies (1).
Show/hide table
Illustration 2 g01175093 - Disconnect harness assembly (2).
Show/hide table
Illustration 3 g01175096 Show/hide table
Illustration 4 g01175097 - Position Tooling (A) below transmission (3).
- Disconnect hose assembly (7).
- Attach a suitable lifting device to rear axle (5). The weight of rear axle (5) and transmission (3) is approximately
794 kg (1750 lb) . - Remove nuts (6) and carefully remove rear axle (5) and transmission (3) from the machine.
Show/hide table
Illustration 5 g01175098 - Attach a suitable lifting device to transmission (3). The weight of transmission (3) is approximately
136 kg (300 lb) . - Remove bolts (8) and transmission (3).
