Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Show/hide table
|
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Show/hide table
|
 |
|
| Illustration 1 | g01175116 |
- Position fuel tank (34) and install bolt (33) .
- Connect hoses (32) and (35) .
Show/hide table
|
 |
|
| Illustration 2 | g01175067 |
- Connect hose assemblies (30) and (31) .
Show/hide table
|
 |
|
| Illustration 3 | g01174934 |
- Position plate assembly (29) and install bolts (28) .
Show/hide table
|
 |
|
| Illustration 4 | g01174844 |
- Install plates (27) and plate assemblies (26) .
Show/hide table
|
 |
|
| Illustration 5 | g01174853 |
- Install plate assembly (24) and plate assembly (25) .
Show/hide table
|
 |
|
| Illustration 6 | g01174789 |
- Position plate assembly (22) and install bolts (23) .
Show/hide table
|
 |
|
| Illustration 7 | g01174716 |
- Connect cable assembly (20) and harness assemblies (21) .
Show/hide table
|
 |
|
| Illustration 8 | g01174749 |
- Install plate assembly (19) .
- Connect cable assembly (17). Tighten nuts (18) .
Show/hide table
|
 |
|
| Illustration 9 | g01174707 |
- Install plate assembly (16). Repeat for the opposite side.
Show/hide table
|
 |
|
| Illustration 10 | g01174629 |
- Position pilot control valve (15). Install bolts (13). Install bracket assembly (14) .
Show/hide table
|
 |
|
| Illustration 11 | g01174627 |
- Connect harness assemblies (12) to top console (11) .
Show/hide table
|
 |
|
| Illustration 12 | g01174626 |
- Install top console (11) and bottom console (10) .
- Install armrest (7). Position lever assembly (9) and install screws (8) .
Show/hide table
|
 |
|
| Illustration 13 | g01174624 |
- Position pilot control valve (4) and install bolts (5). Install bracket assembly (6) .
Show/hide table
|
 |
|
| Illustration 14 | g01174609 |
- Install console assemblies (2) and (3). Install armrest (1) .
- Install the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Inspect/Replace".
- Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
- Fill the fuel tank. Refer to Operation and Maintenance Manual, "Capacities (Refill)".
End By:
Install the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".
