Transmission Oil Cooler - Remove and Install
Removal Procedure
Start By:
- Drain the oil from the transmission cooler.
- Drain the water from the transmission cooler.
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g00676309 |
Show/hide table
Illustration 2 | g00676370 |
- Loosen clamp (1) .
- Disconnect hose (2) .
- Remove four bolts and washers (3) .
- Remove two brackets (4) .
- Remove transmission oil cooler (5) .
Installation Procedure
- Install the transmission cooler (5) .
- Install the two brackets (4) .
- Install the four bolts and washers (3) .
- Connect the hose (2) .
- Tighten the clamp (1) .
Caterpillar Information System:
3500B High Displacement Locomotive Engines Camshaft
3500B High Displacement Locomotive Engines Crankshaft
3176C and 3196 Marine Engines V-Belts - Remove and Install
2000/02/01 Caterpillar Engine Electronics Now Has Many New Features {1900}
3512 and 3516 EUI Engines for Caterpillar Built Machines Fuel System Operation
3176C and 3196 Marine Engines Alternator - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Injection Actuation Pressure Control Valve Circuit - Test
3500B High Displacement Locomotive Engines High Coolant Temperature
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Idle Shutdown Timer - Test
3500B High Displacement Locomotive Engines Engine Overspeed Control
3408E and 3412E Engines for Caterpillar Built Machines Piston and Rings
723PLUS Digital Speed Control Hand Held Programmer and Menus
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Warning Lamp Circuit - Test
2000/02/01 Correction to Guideline for Reusable Parts and Salvage Operations, SEBF8192-02 {1201}
G3406 Engine Charging System
3176C and 3196 Marine Engines Aftercooler - Remove
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Check Engine Lamp Circuit - Test
3176C and 3196 Industrial Engines Cylinder Head - Install
Replacing the Transformer in the Automatic Transfer Switch{4469} Replacing the Transformer in the Automatic Transfer Switch{4469}
3176C and 3196 Marine Engines Aftercooler - Install
C15 and C18 Petrolem Generator Set Engines Factory Passwords
3512B Petroleum Engines with the ADEM 2 Electronic Control Module Customer Parameters Worksheet
3512B and 3512C Engines For Caterpillar Built Machines Load Feedback Capability
3176C and 3196 Marine Engines Air Cleaner - Remove and Install