Rocker Shaft and Pushrod - Remove
Removal Procedure
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put identification marks on each rocker arm in order to identify the proper location in the engine for installation.
Show/hide table
Illustration 1 | g00684105 |
- Remove bolts (1) .
- Remove rocker arm assembly (2) and pushrods (3). Keep each pushrod with the respective rocker arm.
- Remove the valve bridge assemblies.
Caterpillar Information System:
3176C and 3196 Marine Engines Valve Mechanism Cover - Remove and Install
3176C and 3196 Marine Engines Turbocharger - Install
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}
2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
3500 Generator Set Engines Auxiliary Drive Pulley
2000/01/01 Correction to Specifications Module, SENR5117-03, "3116 Diesel Truck Engine" {1201}
3176C and 3196 Marine Engines Turbocharger - Remove
3500B Engines for Caterpillar Built Power Modules Test for the Water Temperature Regulator
2000/02/07 New Oil Filter Base Group {1306}
Electronic Modular Control Panel II+ (EMCP II+) Normal Mode
2000/02/01 Correction To Troubleshooting, SENR5015-00 {1000}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install
3176C and 3196 Marine Engines Inlet and Exhaust Valves - Remove and Install
3176C and 3196 Marine Engines Electronic Unit Injector Sleeve - Install
3176C and 3196 Marine Engines Cylinder Head - Remove
2000/01/01 New Idler Pulley Now Available {1358}
3512B Petroleum Engines High Coolant Temperature
2000/02/01 Shorter Bolts For Mounting The Radiator Support Brace To The Radiator Top Tank Are Used {1353}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3512B Petroleum Engines Altitude Derate Feature