Correction To Troubleshooting, SENR5015-00 {1000}
- Marine Engines:
- 3412E (S/N: 9KS1-UP; 9PW1-UP)
The "Diagnostic Codes" information on page 5-55 of Troubleshooting, SENR5015-00, "P-546: Injection Actuation Pressure Sensor" states that a CID-FMI 164-04 will not occur unless the ECM is bad. This does not mean that the ECM should be replaced before you perform the Functional Test. If a CID-FMI 164-04 is generated, proceed to Step 1 of the Functional Test on page 5-56. Perform the test in order to determine the probable cause of the diagnostic code.
The updated Troubleshooting, SENR5015-01 is now available.
Caterpillar Information System:
3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Remove
3176C and 3196 Marine Engines Valve Mechanism Cover - Remove and Install
3176C and 3196 Marine Engines Turbocharger - Install
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}
2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
3500 Generator Set Engines Auxiliary Drive Pulley
2000/01/01 Correction to Specifications Module, SENR5117-03, "3116 Diesel Truck Engine" {1201}
3176C and 3196 Marine Engines Turbocharger - Remove
3500B Engines for Caterpillar Built Power Modules Test for the Water Temperature Regulator
2000/02/07 New Oil Filter Base Group {1306}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install
3176C and 3196 Marine Engines Inlet and Exhaust Valves - Remove and Install
3176C and 3196 Marine Engines Electronic Unit Injector Sleeve - Install
3176C and 3196 Marine Engines Cylinder Head - Remove
2000/01/01 New Idler Pulley Now Available {1358}
3512B Petroleum Engines High Coolant Temperature
2000/02/01 Shorter Bolts For Mounting The Radiator Support Brace To The Radiator Top Tank Are Used {1353}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3512B Petroleum Engines Altitude Derate Feature
3512B Petroleum Engines Crankcase Pressure