3500B Engines for Caterpillar Built Power Modules Caterpillar

Test for the Water Temperature Regulator

Usage:

PM3508 BLM

Remove the regulator from the engine.

Heat water in a pan until the temperature is 92 °C (198 °F). Stir the water in the pan. This will distribute the temperature throughout the pan.

Hang the water temperature regulator in the pan of water. The water temperature regulator must be below the surface of the water. The water temperature regulator must be away from the sides and the bottom of the pan.

Keep the water at the correct temperature for ten minutes.

After ten minutes, remove the water temperature regulator. After the water temperature regulator has opened, immediately check this distance. The distance must be a minimum of 10.4 mm (0.409 inch).

If the distance is less than 10.4 mm (0.409 inch), make a replacement of the water temperature regulator.

Caterpillar Information System:

2000/02/07 New Oil Filter Base Group {1306}

Electronic Modular Control Panel II+ (EMCP II+) Normal Mode

3608 Engine Fuel System Operation

3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Test

3500B Engines Cylinder Head

3608 Engine Sea Water Cooling System Operation

3176C and 3196 Marine Engines Electronic Unit Injector Sleeve - Remove

3176C and 3196 Marine Engines Electronic Unit Injector - Install

723PLUS Digital Speed Control Watch Window PC Interface

723PLUS Digital Speed Control Programmable Parameters

3176C and 3196 Marine Engines Electronic Unit Injector - Remove

2000/02/01 New Oil Filter Base Group {1306}

3176C and 3196 Marine Engines Turbocharger - Remove

2000/01/01 Correction to Specifications Module, SENR5117-03, "3116 Diesel Truck Engine" {1201}

3500 Generator Set Engines Auxiliary Drive Pulley

2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}

Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}

2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}

2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}

3176C and 3196 Marine Engines Turbocharger - Install

3176C and 3196 Marine Engines Valve Mechanism Cover - Remove and Install

3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Remove

2000/02/01 Correction To Troubleshooting, SENR5015-00 {1000}

3176C and 3196 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install