Fan Drive - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put the fan drive (5) in position on the front housing.
Show/hide table
Illustration 1 | g00517851 |
A Typical Example |
Show/hide table
Illustration 2 | g00517850 |
A Typical Example |
- Install the two bolts (2) and the two nuts (3) loosely.
- Install the fan drive belts (4) and adjust the belt tension. Refer to Testing and Adjusting, "Belt Tension Chart".
Note: Install the belts (4) only as a set.
- Tighten the two bolts (2) and the two nuts (3) that hold the fan drive (5) in position.
Caterpillar Information System:
3176C Industrial Engine Fan Drive - Remove
3512 Industrial Engine Flywheel
723PLUS Digital Speed Control Application
G3304 and G3306 Engines Test Tools for the Electrical System
723PLUS Digital Speed Control Declaration of Incorporation
723PLUS Digital Speed Control Introduction
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI) - Adjust
3126B Engines for Caterpillar Built Machines Unit Injector - Install
3500 Industrial Engines Cylinder Block
G3500B Engines Measuring Engine Oil Pressure
3500 Engines For Caterpillar Built Power Modules General Information (Lubrication System)
3406E and C15 Marine Engines Turbocharger - Disassemble
2000/01/01 New Shafts In Water Pump Groups Provide Increased Torsional Strength {1361, 1389}
3306B Industrial Engine Maintenance Interval Schedule
3114, 3116 and 3126 MUI Engine Governors Throttle Lever (Types IV, V, VI, VII, and Some III) - Remove
3176C Engine Maintenance Interval Schedule
723PLUS Digital Speed Control Control Options
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0100 FMI 13 Engine Oil Pressure calibration required
2000/01/01 Cooling System Venting Procedure {1350}
3176C and 3196 Marine Engines Engine Oil Filter Base
723PLUS Digital Speed Control Hardware Options
3408E and 3412E Engines for Caterpillar Built Machines CID 0042 FMI 05 Injector Actuation Valve open circuit
3408E and 3412E Engines for Caterpillar Built Machines CID 0042 FMI 06 Injector Actuation Valve short to ground
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt