Illustration 1 | g00929561 |
Illustration 2 | g00929565 |
Illustration 3 | g00929563 |
Notices
Illustration 4 | g00911138 |
NOTICE |
---|
Improper lifting or tiedowns can allow load to shift and can cause injury and damage. |
Notice (1) is located on the right side of the machine. The notice is located on the exterior of the cab near the front of the cab.
Lifting point (2) |
Tie down point (3) |
Clean Glass (4)
Notice (4) is located on the windows in the cab.
Illustration 5 | g00911414 |
NOTICE |
---|
Clean windows with a wet cloth or sponge. Dry cloth or sponge may scratch window material. |
Cylinder Installation (5)
Notice (5) is located on the rod end of each hydraulic cylinder.
Illustration 6 | g00911828 |
Key in Run Position (6)
Notice (6) is located on the window on the right side of the cab.
Illustration 7 | g00915002 |
NOTICE |
---|
Key must be in run position with engine running to maintain electrical and hydraulic functions and prevent serious machine damage. |
Instructional Messages
Do Not Touch (7)
This message is located on the radiator. This message is also located twice on the engine cover.
Illustration 8 | g00911159 |
Do not touch this location. The surface of this object may be hot.
No Step (8)
This message is located on the engine cover on the top of the machine.
Illustration 9 | g00911158 |
Do not step in this area.
Radial Air Cleaner (9)
This message is located on the cover of the air cleaner.
Illustration 10 | g00911166 |
In order to avoid engine damage, replace old filters with radial seal air filters. Other replacement filters will not seal.
Radial seal filter gasket design and radial seal filter gasket location are critical to the proper operation of the air cleaner element. Use only Caterpillar replacements.
Hydraulic Oil (10)
This message is located on the hydraulic tank. This message is located near the hydraulic oil level gauge.
Illustration 11 | g00911169 |
Check oil level daily.
Machine positioned with stick vertical and and implement on ground.
- With cold oil
- Oil level should be between low and middle mark
- With warm oil
- Oil level should be between middle and high mark
Alternate Exit (Primary) (11)
This message is located on the rear window of the cab.
Illustration 12 | g00911175 |
If the primary exit is blocked, exit the machine through the rear window.
Alternate Exit (secondary) (12)
This message is located on the rear window of the cab. This message is located in the upper right corner of the rear window.
Illustration 13 | g00911516 |
If the primary exit is blocked, exit the machine through the rear window.
Joystick Control (Standard) (13)
This message is located on the right window of the cab.
Illustration 14 | g00911202 |
Throttle Control Switch (14)
This message is located on the right side console in the cab of the machine.
Illustration 15 | g00911613 |
Air Conditioner plate (15)
This message is located inside the cab on the left side.
Illustration 16 | g00900510 |