Electric Starting Motor
Show/hide table
图 1 | g00295928 |
起动马达(侧视图) |
Show/hide table
图 2 | g00295930 |
显示电气连接的起动马达的端视图 |
12 伏起动马达
注: 从驱动端观察起动装置时,起动马达顺时针旋转。
25° C (77° F) 空载条件
- 轴的转速 ... 最小 7000
- 电流 ... 最大 130 安
- 电压 ... 11.5 伏
- 额定电压 ... 12 伏
- 电流 ... 最大 130 安
马达电刷弹簧的张力 ... 8.34 至 11.00 N (1.9 至 2.5 lb)
起动装置电缆在 200°C (392°F) 和 12 伏下的最小电阻 ... 0.0017 欧姆
25°C (77 °F) 时的拉动电流 ... 12 伏时为 60 安
25°C (77 °F) 时的保持电流 ... 12 伏时为 12 安
(1) 将蓄电池接线端螺母拧紧至以下扭矩。 ... 24 至 32 N·m (18 至 24 lb ft)
(2) 将开关接线端螺母拧紧至以下扭矩。 ... 1.0 至 1.3 N·m (9 至 12 lb in)
24 伏起动马达
25° C (77° F) 空载条件
- 轴的转速 ... 最小 7000
- 电流 ... 最大 85 安
- 电压 ... 23 伏
- 额定电压 ... 24 伏
- 电流 ... 最大 85 安
最小下拉电压 ... 18 伏
电刷长度
- 最小电刷长度 ... 15.5 mm (0.61 in)
电枢端隙 ... 0.1 至 0.3 mm (0.004 至 0.012 in)
增减垫片以将电枢端隙调整至正确的技术规格。
转接器
- 新直径 ... 45 mm (1.77 in)
- 最小直径 ... 42.5 mm (1.67 in)
(1) 将蓄电池接线端螺母拧紧至以下扭矩。 ... 24 至 32 N·m (18 至 24 lb ft)
(2) 将开关接线端螺母拧紧至以下扭矩。 ... 1.0 至 1.3 N·m (9 至 12 lb in)
Caterpillar Information System:
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Install
Caterpillar Monitoring System for Electronic Modular Control Panel Sensor Dynamic Test
3054B Industrial Engine Engine Oil Relief Valve
3054B Industrial Engine Air Inlet Heater
C-9 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor
3612 and 3616 Engines Cylinder Head - Disassemble
C-9 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
3512B Marine Auxiliary Engine After Starting Engine
C-9 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor
C9 Urban Transit Bus Engine Speed/Timing Sensor
Caterpillar Monitoring System for Electronic Modular Control Panel Sensor Signal Voltage - Test
Caterpillar Monitoring System for Electronic Modular Control Panel Pulse Width Modulated (PWM) Sensor - Test
C-9 Engines for Caterpillar Built Machines Cooling System
C-9 Engines for Caterpillar Built Machines Electrical System
G3606 and G3608 Engines Water Temperature Regulator and Housing - Disassemble
3054B Industrial Engine Cylinder Block
G3606 and G3608 Engines Water Temperature Regulator and Housing - Assemble
3512B Marine Auxiliary Engine Generator Oil - Change
3114, 3116, and 3126 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
G3606 and G3608 Engines Water Temperature Regulator and Housing - Install
3612 and 3616 Engines Cylinder Head - Assemble
3512B Marine Auxiliary Engine Generator Oil Filter - Change
3512B Marine Auxiliary Engine Generator Oil Filter Indicator - Check
3512B Marine Auxiliary Engine Generator Oil Level - Check