Air Inlet Heater
Show/hide table
Illustration 1 | g00298861 |
(1) Electrical connection (2) Fuel inlet (3) Ball valve (4) Valve holder (5) Wire coil (6) Ignition coil |
Voltage ... 12 volts
Current draw ... 13.5 amperes
Tighten the air inlet heater to the inlet manifold to the following torque: ... 31 N·m (23 lb ft)
Fuel flow through the air inlet heater per minute ... 3.5 to 5.9 cc (0.21 to 0.36 in3)
Caterpillar Information System:
C-9 Engines for Caterpillar Built Machines Engine Oil Pressure Sensor
3612 and 3616 Engines Cylinder Head - Disassemble
C-9 Engines for Caterpillar Built Machines Atmospheric Pressure Sensor
3512B Marine Auxiliary Engine After Starting Engine
C-9 Engines for Caterpillar Built Machines Inlet Air Temperature Sensor
C9 Urban Transit Bus Engine Speed/Timing Sensor
Caterpillar Monitoring System for Electronic Modular Control Panel Sensor Signal Voltage - Test
Caterpillar Monitoring System for Electronic Modular Control Panel Pulse Width Modulated (PWM) Sensor - Test
3114, 3116, and 3126 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Multi-Torque - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Engine Temperature Sensor Open or Short Circuit - Test
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Engine Pressure Sensor Open or Short Circuit - Test
3054B Industrial Engine Engine Oil Relief Valve
Caterpillar Monitoring System for Electronic Modular Control Panel Sensor Dynamic Test
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Install
3056E Industrial Engine Electric Starting Motor
C-9 Engines for Caterpillar Built Machines Cooling System
C-9 Engines for Caterpillar Built Machines Electrical System
G3606 and G3608 Engines Water Temperature Regulator and Housing - Disassemble
3054B Industrial Engine Cylinder Block
G3606 and G3608 Engines Water Temperature Regulator and Housing - Assemble
3512B Marine Auxiliary Engine Generator Oil - Change
3114, 3116, and 3126 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
G3606 and G3608 Engines Water Temperature Regulator and Housing - Install