Generator Oil Filter - Change
Replace the oil filter for the generator when either of the following conditions occur:
- The indicator for the filter is in the red zone.
- The oil for the generator is changed.
- Remove two bolts and washers (1).
- Remove filter case (2) and the element. Dispose of the used element.
- Clean the inside of the filter case with clean, nonflammable solvent.
- Inspect a new element for good condition. Install the element into the filter case.
- Place the filter case into position. Secure the filter with two bolts and washers (1).
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
Illustration 1 | g00641818 |
Caterpillar Information System:
3612 and 3616 Engines Cylinder Head - Assemble
G3606 and G3608 Engines Water Temperature Regulator and Housing - Install
3114, 3116, and 3126 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
3512B Marine Auxiliary Engine Generator Oil - Change
G3606 and G3608 Engines Water Temperature Regulator and Housing - Assemble
3054B Industrial Engine Cylinder Block
G3606 and G3608 Engines Water Temperature Regulator and Housing - Disassemble
C-9 Engines for Caterpillar Built Machines Electrical System
C-9 Engines for Caterpillar Built Machines Cooling System
3056E Industrial Engine Electric Starting Motor
3114, 3116, and 3126 Engines for Caterpillar Built Machines Cylinder Head - Install
Caterpillar Monitoring System for Electronic Modular Control Panel Sensor Dynamic Test
3512B Marine Auxiliary Engine Generator Oil Filter Indicator - Check
3512B Marine Auxiliary Engine Generator Oil Level - Check
Caterpillar Monitoring System for Electronic Modular Control Panel Module - Replace
Battery Test Procedure {1401} Battery Test Procedure {1401}
C-9 Engines for Caterpillar Built Machines Injection Actuation Oil Temperature Sensor
3054 and 3056 Industrial and Generator Set Engines Engine Oil Pressure
Caterpillar Monitoring System for Electronic Modular Control Panel Main Display Module Initialization - Adjust
Caterpillar Monitoring System for Electronic Modular Control Panel Harness Code - Troubleshoot
Caterpillar Monitoring System for Electronic Modular Control Panel System Self Test
Caterpillar Monitoring System for Electronic Modular Control Panel Electrical Connector - Inspect
Caterpillar Monitoring System for Electronic Modular Control Panel Glossary of Terms
Caterpillar Monitoring System for Electronic Modular Control Panel Connector Contact Description of Main Display Module