Swing Motor - Install
Note: Cleanliness is an important factor. Before installation, all components and mating surfaces should be thoroughly clean. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Inspect all gaskets and seals. If any gaskets or seals are damaged or worn, use new gaskets or seals for replacement. All installation procedures should be performed in a clean work area.
- Attach a suitable lifting device and a hoist to swing motor (6).
Note: The swing motor weighs approximately
45 kg (99 lb) .Show/hide tableIllustration 1 g00794421 - Use the hoist to align swing motor (6) on the swing drive.
- Use bolts (8) to secure swing motor (6) to the swing drive.
Show/hide table
Illustration 2 g00794418 - Connect oil drain hose (7) to swing motor (6).
Show/hide table
Illustration 3 g00794415 - Connect hoses (5) to swing motor (6).
Note: Refer to the markings on the hoses when you connect the hoses (5).
Show/hide tableIllustration 4 g00794409 - Install tubes (4) for the stick on the implement and travel control valve.
Show/hide table
Illustration 5 g00794408 - Install cover (3) above the implement and travel control valve.
Show/hide table
Illustration 6 g00793855 - Install hoses (1) for the stick and hoses (2) for the bucket.
- Fill the hydraulic system with oil. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Caterpillar Information System:
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Fuel Transfer Pump (Refueling) - If Equipped
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Tool Box
322C Excavator Machine System Specifications Relief Valve (Line) - Auxiliary
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Power Receptacle
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Battery Disconnect Switch
5110B Excavator Machine Systems Swing Motor - Remove
311C and 314C Excavators Electric and Electronic Monitor - Disassemble
BA22, BA25 and BA30 Angling Brooms General Information
311C and 314C Excavators Electric and Electronic Service Hour Meter Does Not Activate - Troubleshoot
311C and 314C Excavators Electric and Electronic Speed Sensor - Troubleshoot
311C and 314C Excavators Electric and Electronic Speed Sensor - Replace
311C and 314C Excavators Electric and Electronic Starting Motor Does Not Rotate - Troubleshoot
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Mirror
5230B Excavator Machine Systems Swing Parking Brake - Remove
311C U Excavator Hydraulic System Pilot Valve (Travel and Steering)
311C U Excavator Hydraulic System Travel Motor
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Alternate Exit
5230B Excavator Machine Systems Swing Parking Brake - Install
5110B Excavator Machine Systems Swing Drive - Remove
5110B Excavator Machine Systems Swing Drive - Install
311C U Excavator Hydraulic System Swing Motor
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Window Wiper and Washer Control
325C and 325C L Excavator Stopping the Engine
325C and 325C L Excavator Specifications