Required Tools | |||
---|---|---|---|
Item | Qty | Part Number | Description |
A | 2 | 439-3939 | Link Bracket |
Start By:
- Remove the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Remove".
Personal injury can result from hydraulic oil under pressure. Hydraulic oil under pressure can cause injury to persons on or near the machine when the pressure is suddenly released. At operating temperature, the hydraulic oil tank is hot and under pressure. Hot oil can cause burns. Remove the fill plug only when the engine is stopped, and the fill plug is cool enough to touch with your bare hand. Do not allow hot oil or components to contact skin. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
NOTICE |
---|
Keep all parts clean from contaminants. Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components. To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly. Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination. |
- Install tooling (A) on swing parking brake (1).
- Attach a suitable lifting device and a hoist to swing parking brake (1).
Note: The swing parking brake weighs approximately
45 kg (99 lb) .Show/hide tableIllustration 2 g00794530 Note: Illustration 2 shows the swing motor that is still installed on the swing parking brake.
- Disconnect hose (2) that supplies lubrication oil to the swing drive.
- Disconnect hose (3) that supplies brake retract pressure to swing parking brake (1).
- Remove oil level gauge (4) from swing parking brake (1).
- Remove 16 bolts (5) that secure swing parking brake (1) to the swing drive. Use the hoist to lift swing parking brake (1) off the swing drive.
Show/hide table
Illustration 3 g00794539 - Remove input shaft (6) from the swing drive.
Illustration 1 | g00794523 |