Required Tools | |||
---|---|---|---|
Item | Qty | Part Number | Description |
A | 2 | 138-7574 | Link Bracket |
Start By:
- Remove the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Remove".
Personal injury can result from hydraulic oil under pressure. Hydraulic oil under pressure can cause injury to persons on or near the machine when the pressure is suddenly released. At operating temperature, the hydraulic oil tank is hot and under pressure. Hot oil can cause burns. Remove the fill plug only when the engine is stopped, and the fill plug is cool enough to touch with your bare hand. Do not allow hot oil or components to contact skin. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
NOTICE |
---|
Keep all parts clean from contaminants. Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components. To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly. Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination. |
- Install Tooling (A) on the swing parking brake that is attached to swing drive (1).
- Attach a suitable lifting device and a hoist to swing drive (1).
Note: The swing drive weighs approximately
630 kg (1389 lb) .Show/hide tableIllustration 2 g00794593 Note: Illustration 2 shows the swing motor that is still installed on the swing parking brake.
- Disconnect hose (2) that supplies lubrication oil to swing drive (1).
- Disconnect hose (3) that supplies brake retract pressure to the swing parking brake.
- Remove the 26 bolts (4) that secure swing drive (1) to the swing frame.
- Use the hoist to lift swing drive (1) off the machine.
Illustration 1 | g00794589 |