Speed Sensor - Replace
Show/hide table
 | |
| Illustration 1 | g00667337 |
Engine speed sensor (1) Speed sensor (2) Locknut (3) Magnetic core (4) Gear (5) Flywheel housing (A) Clearance in millimeters | |
Show/hide table
| NOTICE |
|---|
Perform this maintenance with the engine stopped. |
- Turn the key start switch and the disconnect switch to the OFF position.
- Slowly tighten speed sensor (1) into flywheel housing (5) until magnetic core (3) contacts gear (4) .
- Turn speed sensor (1) counterclockwise. The turn should be approximately 3/4 of a rotation.
- Temporarily tighten locknut (2) .
- Set the engine speed dial at position 1 (LOW IDLE position).
- Start the engine.
- Ensure that the engine speed is 800 rpm.
- If the engine speed is not 800 rpm, tighten speed sensor (1) up to 1/3 of 1 turn.
- Tighten locknut (2) to a torque of 25 N·m (18.4 lb ft).
- Ensure that the engine speed corresponds to the position of the engine speed dial.
Caterpillar Information System:
311C and 314C Excavators Electric and Electronic Starting Motor Does Not Rotate - Troubleshoot
311C and 314C Excavators Electric and Electronic Wiper Motor Does Not Stop - Troubleshoot
311C and 314C Excavators Electric and Electronic Wiper Motor Does Not Rotate - Troubleshoot
311C and 314C Excavators Electric and Electronic Window Washer Does Not Activate - Troubleshoot
311C and 314C Excavators Electric and Electronic Travel Pressure Switch - Troubleshoot
311C and 314C Excavators Electric and Electronic Travel Alarm Sounds while Travel Controls Are Released - Troubleshoot
311C and 314C Excavators Electric and Electronic Travel Alarm Does Not Sound - Troubleshoot
311C and 314C Excavators Electric and Electronic Timer - Troubleshoot
315C Excavator Engine - Install
311C and 314C Excavators Electric and Electronic System Schematic
311C and 314C Excavators Electric and Electronic Radio Does Not Sound - Troubleshoot
311C and 314C Excavators Electric and Electronic Radio Does Not Activate - Troubleshoot
311C and 314C Excavators Electric and Electronic Speed Sensor - Troubleshoot
311C and 314C Excavators Electric and Electronic Service Hour Meter Does Not Activate - Troubleshoot
BA22, BA25 and BA30 Angling Brooms General Information
311C and 314C Excavators Electric and Electronic Monitor - Disassemble
5110B Excavator Machine Systems Swing Motor - Remove
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Battery Disconnect Switch
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Power Receptacle
322C Excavator Machine System Specifications Relief Valve (Line) - Auxiliary
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Tool Box
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Fuel Transfer Pump (Refueling) - If Equipped
5110B Excavator Machine Systems Swing Motor - Install
M316C, M318C and M322C Excavators and M318C MH and M322C MH Material Handlers Mirror