Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Caterpillar

Programmable Spare Relay Outputs

Usage:

3516B 1NW

The programmable spare relay is one of the relays that is located in the relay module that is on the rear of the GSC+. The programmable spare relay outputs respond to a selected trigger condition. The response and the trigger condition are programmable.

The GSC+ (setpoint SP15) must be programmed. The programmable spare relay outputs are active or inactive. In an active state, the normally open contacts will close and the normally closed contacts will open.

The condition that triggers the programmable spare relay outputs to the active state must be programmed in the GSC+ (setpoint SP16). The possible trigger conditions that can activate the programmable spare relay outputs are listed in System Operation, "Spare Input/Output Programming OP6".

See System Operation, "Spare Input/Output Programming OP6" for more information on programming the setpoints for this output.

Note: The GSC+ diagnoses a fault in the spare output circuit. See Testing and Adjusting, "CID 448, FMI 12 Programmable Spare Relay Failed-Test" for more information.

Caterpillar Information System:

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Diagnostic Codes

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines SP Fault Codes

3612 and 3616 Engines Engine Oil Pump - Assemble

3500B High Displacement Locomotive Engines Electronic Control Module (ECM)

3500 Spark Ignited Engines Gas Pressure Regulator

3612 and 3616 Engines Engine Oil Pump - Disassemble

EMCPII+ for Gas Engines AL Fault Codes

EMCPII+ for Gas Engines Fault Description

3618 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install

3612 and 3616 Engines Governor Drive - Assemble - Earlier

Installation Of The 174-8943 Sleeve Into The 3408E And 3412E Unit Injector Hydraulic Pump{1714} Installation Of The 174-8943 Sleeve Into The 3408E And 3412E Unit Injector Hydraulic Pump{1714}

Caterpillar Monitoring System for Electronic Modular Control Panel Sensors

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Programmable Spare Output

Caterpillar Monitoring System for Electronic Modular Control Panel Modes Of Operation

C9 On-Highway Truck Engines Unit Injector Hydraulic Pump - Install

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Programmable Kilowatt Level Output

3618 Engine Crankcase Explosion Relief Valve - Remove and Install

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Modules

3612 and 3616 Engines Water Pump - Remove - Jacket Water Pump

EMCPII+ for Gas Engines Alarm Module Control (NFPA 110)

SR4 HV and SR4B HV Generators Generator Terminal Connections

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Module Control (Custom)

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Relay Driver Module

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Synchronizing Lights Module