Governor Drive - Assemble - Earlier
组装步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件说明 | 数量 |
| A | 1P-0510 | 起子总成 | 1 |
- 如已将轴承从壳体 (4) 上卸下，使用工具 (A) 并将轴承安装在壳体中。 轴承内径必须为 24.993 ± 0.033 mm (0.9840 ± 0.0013 inch)。
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
 | |
| 图 1 | g00627067 |
- 将小齿轮 (3) 放置在壳体 (4) 中。 安装止推垫圈 (2) 和将止推垫圈固定到位的螺栓。
- 将联轴器 (1) 放置在小齿轮 (3) 的合适位置上。
End By: 安装调速器驱动装置。 请参阅 拆解和装配, "调速器驱动装置 - 安装"。
Caterpillar Information System:
Installation Of The 174-8943 Sleeve Into The 3408E And 3412E Unit Injector Hydraulic Pump{1714} Installation Of The 174-8943 Sleeve Into The 3408E And 3412E Unit Injector Hydraulic Pump{1714}
Caterpillar Monitoring System for Electronic Modular Control Panel Sensors
C-9 Engines for Caterpillar Built Machines Crankshaft
3054 and 3056 Industrial and Generator Set Engines Fuel Transfer Pump
SR4 and SR4B Generators and Control Panels Manual Operation
3618 Engine Aftercooler - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AC Offset Adjustment OP10
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Engine Setpoint Verification OP9
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Voltmeter/Ammeter Programming OP8
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines System Overview
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Hourmeter Programming OP7
3406E and 3456 Generator Set Engines Fuel Filter Base - Assemble
3618 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install
EMCPII+ for Gas Engines Fault Description
EMCPII+ for Gas Engines AL Fault Codes
3612 and 3616 Engines Engine Oil Pump - Disassemble
3500 Spark Ignited Engines Gas Pressure Regulator
3500B High Displacement Locomotive Engines Electronic Control Module (ECM)
3612 and 3616 Engines Engine Oil Pump - Assemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines SP Fault Codes
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Diagnostic Codes
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Programmable Spare Relay Outputs
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Programmable Spare Output
Caterpillar Monitoring System for Electronic Modular Control Panel Modes Of Operation