Unit Injector Hydraulic Pump - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 5P-0327 | Crowfoot Wrench | 1 |
B | 180-0186 | Removal Tool | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position drive gear (8) on the unit injector hydraulic pump. Install the bolt on the unit injector hydraulic pump. Tighten the bolt to a torque of
110 ± 14 N·m (81 ± 10 lb ft) . - Lubricate O-ring seal (7) with clean engine oil. Install the O-ring seal on the unit injector hydraulic pump.
Show/hide table
Illustration 2 g01025536 - Position unit injector hydraulic pump (5) on the front housing. Install bolts (6) and tighten bolts (6) to a torque of
28 ± 7 N·m (20 ± 5 lb ft) .Note: If the engine is equipped with a tube assembly then proceed to Step 4. If the engine is equipped with a hose assembly then go to Step 6.
- Use Tooling (A) to install tube assembly (1) and tube assembly (2).
Note: If the engine is equipped with a hose assembly, use Tooling (B). Connect fitting (4).
- Connect harness assembly (3).
- Use Tooling (A) to install tube assembly (2).
Show/hide table
Illustration 1 | g01025556 |
Caterpillar Information System:
G3304 and G3306 Engines Valve Cover
3500B Engines Water Pump - Install
G3612 and G3616 Engines Generator - Remove and Install
3044C Industrial Engine Fuel Conservation Practices
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 447 FMI 12 Fuel Control Relay Failed - Test
SR4B Generators Generator - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
G3612 and G3616 Engines Air Starting Motor - Disassemble
3114, 3116 and 3126 Engines Engine Overspeeds on Start
3034 Industrial Engine Cold Weather Starting
G3612 and G3616 Engines Air Inlet Elbow - Remove and Install
G3612 and G3616 Engines Air Inlet Choke - Assemble
G3304 and G3306 Engines Valve Cover
3306C Engines for Caterpillar Built Machines Gear Group (Front)
G3304 and G3306 Engines Engine Support
Generator Set Load Sensor Droop - Adjust
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 560 FMI 11 CAT Data Link Failure Mode Not Identified - Test
Electronic Modular Control Panel II (EMCP II) For MUI Engines SP Fault Code - Troubleshoot
3512B Marine Auxiliary Engine MID 036 - CID 0289 - FMI 13 Unfiltered Fuel Pressure calibration required
3126B Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3512B Marine Auxiliary Engine MID 036 - CID 0542 - FMI 13 Unfiltered Engine Oil Pressure cal required
3512B Marine Auxiliary Engine MID 036 - CID 1335 - FMI 03 DLO Eng Filter In Press Sensor open/short to +batt
3126B Engines for Caterpillar Built Machines Turbocharger - Remove
3512B Marine Auxiliary Engine MID 036 - CID 1335 - FMI 04 DLO Engine Filter Inlet Press Sensor short to gnd