3512B Marine Auxiliary Engine Caterpillar


MID 036 - CID 1335 - FMI 03 DLO Eng Filter In Press Sensor open/short to +batt

Usage:

3512 4DR
Conditions Which Generate This Code:

The primary Electronic Control Module (ECM) reads signal voltage that is greater than 4.8 VDC for one second. The ECM has been powered for three seconds. The diagnostic codes 262-03 and 262-04 are not active.

System Response:

The CID-FMI is logged in memory. The CID-FMI may be viewedon a display module or on the Caterpillar Electronic Technician (ET). The ECM flags the filtered diesel lube oil inlet pressure as invalid data. A default value of 500 kPa (73 psi) is used.

Test Step 1. Perform the following test: Engine Sensor Open/Short Test

Results:

  • OK - Stop.

  • REPAIRED, OK - Stop.

Caterpillar Information System:

3512B Marine Auxiliary Engine MID 036 - CID 0542 - FMI 13 Unfiltered Engine Oil Pressure cal required
3126B Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3512B Marine Auxiliary Engine MID 036 - CID 0289 - FMI 13 Unfiltered Fuel Pressure calibration required
Electronic Modular Control Panel II (EMCP II) For MUI Engines SP Fault Code - Troubleshoot
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 560 FMI 11 CAT Data Link Failure Mode Not Identified - Test
Generator Set Load Sensor Droop - Adjust
G3304 and G3306 Engines Engine Support
3306C Engines for Caterpillar Built Machines Gear Group (Front)
G3304 and G3306 Engines Valve Cover
3126B and 3126E On-highway Engines Unit Injector Hydraulic Pump - Install
G3304 and G3306 Engines Valve Cover
3500B Engines Water Pump - Install
3126B Engines for Caterpillar Built Machines Turbocharger - Remove
3512B Marine Auxiliary Engine MID 036 - CID 1335 - FMI 04 DLO Engine Filter Inlet Press Sensor short to gnd
Generator Set Load Sensor Load Gain - Adjust
3512B Marine Auxiliary Engine MID 036 - CID 1336 - FMI 03 DLO Engine Inlet Press Sensor open/short to +batt
Generator Set Load Sensor Wiring Diagrams
3512B Marine Auxiliary Engine MID 036 - CID 1336 - FMI 04 DLO Engine Inlet Press Sensor short to gnd
3512B Marine Auxiliary Engine MID 036 - CID 1337 - FMI 03 DLO Pump Discharge Press Sens open/short to +batt
3512B Marine Auxiliary Engine MID 036 - CID 1337 - FMI 04 DLO Pump Discharge Press Sensor short to gnd
3512B Marine Auxiliary Engine MID 036 - CID 1338 - FMI 03 DO Engine Filter In Press Sens open/short to +batt
3512B Marine Auxiliary Engine MID 036 - CID 1338 - FMI 04 DO Engine Filter Inlet Press Sensor short to gnd
G3304 and G3306 Engines Magneto Drive
3512B Marine Auxiliary Engine MID 036 - CID 1339 - FMI 03 DO Eng Filter Out Press Sensor open/short to +batt
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.