Drift Reduction Valve (Boom) - Remove
Removal Procedure
Show/hide table
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove five bolts (1) and the washers. Remove walkway (2) .
Show/hide table
Illustration 1 | g00609831 |
- Remove electrical connector (3) .
Show/hide table
Illustration 2 | g00602880 |
- Disconnect clip (5) that holds hose (4) to pipe (8) .
- Remove bolts (6) from pipe (8) .
- Disconnect hose (7) .
- Disconnect two hose assemblies (9) .
Show/hide table
Illustration 3 | g00609834 |
- Remove two bolts (11) and the washers. Remove clamp (10) .
Show/hide table
Illustration 4 | g00609837 |
- Use a suitable tie to hold pipe (8) away from the drift reduction valve (13). Fasten a lifting strap and a hoist to the drift reduction valve (13). Remove bolts (12). The weight of the valve is 36 kg (80 lb).
Note: Tube (8) will cause some obstruction. Rotate the drift reduction valve toward the counterweight.
Show/hide table
Illustration 5 | g00602932 |
- Remove the drift reduction valve (13) from the machine.
Show/hide table
Illustration 6 | g00602933 |
Caterpillar Information System:
A13 Auger Maintenance Interval Schedule
307B Excavator Monitoring System
307B Excavator Power Receptacle - If Equipped
3064 and 3066 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
307B Excavator Operator's Compartment
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
W330B Material Handler Operating Technique Information
365B and 365B Series II Excavators Supplement for 3196 Engine Water Separator - Remove and Install
365B and 365B Series II Excavators Supplement for 3196 Engine Battery - Remove and Install
W330B Material Handler Equipment Lowering with Engine Stopped
3126B and 3126E On-highway Engines Alternator - Remove and Install
5230 Excavator Hydraulic System True Load Sensing Signal - Test
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Drift Reduction Valve (Boom) - Install
3064 and 3066 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
3126B and 3126E On-highway Engines Air Compressor Drive Gear - Remove and Install
SR4B Generators Generator Operation
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Remove
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Install
3126B Engines for Caterpillar Built Machines Crankshaft - Remove
307B Excavator Lift Capacities
3126B Engines for Caterpillar Built Machines Crankshaft - Install
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Disassemble
C-9 Engines for Caterpillar Built Machines Valve Mechanism Cover
307B Excavator Machine System Specifications Recoil Spring