Maintenance Interval Schedule
Note: All safety information, warnings and instructions must be read and understood before you perform any operation or any maintenance procedure.
Bracket Pivot Pin - Lubricate
Drive Housing Pivot Pin - Lubicate
Drive Shaft Hub Bearing - Lubricate
Frame Mounting Bracket - Inspect
Pilot Tooth - Inspect/Replace
Walk-Around Inspection
Chain - Lubricate
Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.
Daily
Auger Bit Tooth - Inspect/ReplaceBracket Pivot Pin - Lubricate
Drive Housing Pivot Pin - Lubicate
Drive Shaft Hub Bearing - Lubricate
Frame Mounting Bracket - Inspect
Pilot Tooth - Inspect/Replace
Walk-Around Inspection
Every 50 Service Hours
Chain - Inspect/AdjustChain - Lubricate
Caterpillar Information System:
307B Excavator Monitoring System
307B Excavator Power Receptacle - If Equipped
3064 and 3066 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
307B Excavator Operator's Compartment
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
W330B Material Handler Operating Technique Information
365B and 365B Series II Excavators Supplement for 3196 Engine Water Separator - Remove and Install
365B and 365B Series II Excavators Supplement for 3196 Engine Battery - Remove and Install
W330B Material Handler Equipment Lowering with Engine Stopped
3126B and 3126E On-highway Engines Alternator - Remove and Install
5230 Excavator Hydraulic System True Load Sensing Signal - Test
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Drift Reduction Valve (Boom) - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Drift Reduction Valve (Boom) - Install
3064 and 3066 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
3126B and 3126E On-highway Engines Air Compressor Drive Gear - Remove and Install
SR4B Generators Generator Operation
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Remove
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Install
3126B Engines for Caterpillar Built Machines Crankshaft - Remove
307B Excavator Lift Capacities
3126B Engines for Caterpillar Built Machines Crankshaft - Install
3064 and 3066 Engines for Caterpillar Built Machines Water Pump - Disassemble
C-9 Engines for Caterpillar Built Machines Valve Mechanism Cover