Water Separator - Remove and Install
Removal Procedure
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Put identification marks on all lines and all hoses for installation purposes. Cap all lines and all hoses in order to prevent foreign material from entering the fuel system.
- Unlock and open the access cover (1) on the left side of the machine behind the operator's platform.
Show/hide table
 | |
| Illustration 1 | g00610079 |
- Disconnect hose (2) .
Show/hide table
 | |
| Illustration 2 | g00610167 |
- Disconnect hose (4) .
- Disconnect hose (6) .
- Remove two bolts and the two washers (3) .
- Remove water separator (5) .
Installation Procedure
- Place the water separator (5) in position and install two washers and two bolts (3) .
Show/hide table
| | |
| Illustration 3 | g00610167 |
- Connect hose (6) .
- Connect hose (4) .
- Connect hose (2) .
- Close and lock the access cover (1) on the left side of the machine behind the operator's platform.
Show/hide table
| | |
| Illustration 4 | g00610079 |
Caterpillar Information System:
365B and 365B Series II Excavators Supplement for 3196 Engine Battery - Remove and Install
W330B Material Handler Equipment Lowering with Engine Stopped
3126B and 3126E On-highway Engines Alternator - Remove and Install
5230 Excavator Hydraulic System True Load Sensing Signal - Test
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
3406E and 3456 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
C-9 Engines for Caterpillar Built Machines Engine Design
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Install
3406E and 3456 Engines for Caterpillar Built Machines Solenoid Valve (Compression Brake) - Test
3406E and 3456 Engines for Caterpillar Built Machines Control Valve (Compression Brake) - Test
385B Excavator Safety Messages
C15 Petroleum Generator Set Engines Piston Ring Groove - Inspect
W330B Material Handler Operating Technique Information
3064 and 3066 Engines for Caterpillar Built Machines Rocker Shaft - Assemble
307B Excavator Operator's Compartment
3064 and 3066 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
307B Excavator Power Receptacle - If Equipped
307B Excavator Monitoring System
A13 Auger Maintenance Interval Schedule
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Drift Reduction Valve (Boom) - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Drift Reduction Valve (Boom) - Install
3064 and 3066 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
3126B and 3126E On-highway Engines Air Compressor Drive Gear - Remove and Install
SR4B Generators Generator Operation