Front Idler - Disassemble
Disassembly Procedure
Start By:
- Remove the track. Refer to Disassembly and Assembly, "Track - Remove and Install".
- Remove the front idler and the hydraulic track adjuster. Refer to Disassembly and Assembly, "Front Idler and Track Adjuster - Remove".
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
- Remove two bolts (1) and washers from the supports.
Show/hide table
Illustration 1 | g00577161 |
- Remove two supports (2) from the idler.
- Remove two dust seals (3) from the idler.
- Remove two snap rings (4) from the idler.
- Remove two bearings (5) from the idler.
- Remove shaft (6) from idler (7) .
- Repeat Step 1 through 6 for the front idler on the other side of the machine.
Caterpillar Information System:
S3 Shear and CR3 Crusher Cutting Arm
302.5 Mini Hydraulic Excavator Machine Systems Front Idler and Track Adjuster - Remove
302.5 Mini Hydraulic Excavator Machine Systems Track Carrier Roller - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Track Roller - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Track - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Cab - Remove and Install
312B Excavator Machine Systems Travel Motor - Disassemble
302.5 Mini Hydraulic Excavator Machine Systems Cab Heater - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Seat - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Fuel Tank - Install
302.5 Mini Hydraulic Excavator Machine Systems Fuel Tank - Remove
302.5 Mini Hydraulic Excavator Machine Systems Counterweight - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Front Idler - Assemble
302.5 Mini Hydraulic Excavator Machine Systems Track Adjuster - Disassemble
302.5 Mini Hydraulic Excavator Machine Systems Track Adjuster - Assemble
302.5 Mini Hydraulic Excavator Machine Systems Front Idler and Track Adjuster - Install
302.5 Mini Hydraulic Excavator Machine Systems Recoil Spring - Remove
302.5 Mini Hydraulic Excavator Machine Systems Recoil Spring - Disassemble
302.5 Mini Hydraulic Excavator Machine Systems Recoil Spring - Assemble
302.5 Mini Hydraulic Excavator Machine Systems Recoil Spring - Install
302.5 Mini Hydraulic Excavator Machine Systems Final Drive Sprocket - Remove and Install
302.5 Mini Hydraulic Excavator Machine Systems Piston Motor (Travel) - Remove
302.5 Mini Hydraulic Excavator Machine Systems Piston Motor (Travel) - Disassemble
302.5 Mini Hydraulic Excavator Machine Systems Piston Motor (Travel) - Assemble