Water Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the condition of the gaskets and the O-ring seals. If the gaskets or the O-ring seals are worn or damaged, use new parts for replacement.
- Install O-ring seal (7) on the water pump.
Show/hide table
 | |
| Illustration 1 | g01030505 |
- Put water pump (5) in position and install bolts (6) .
Show/hide table
 | |
| Illustration 2 | g01030504 |
Show/hide table
 | |
| Illustration 3 | g01030503 |
- Install cover (4) and bolts (3) .
- Slide the hose in position on cover (4). Install hose clamps (1) and (2) .
End By: Install the engine oil cooler. Refer to Disassembly and Assembly, "Engine Oil Cooler - Install".
Caterpillar Information System:
3500B Engines and 3500 Engines with EUI Option Electronic Display Module
3034 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Install
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Part Number Location
3500B and 3500B High Displacement Generator Set Engines Self-Diagnostics
3406E and 3456 Generator Set Engines Water Pump - Remove
3406E and C15 Marine Engines Air Starting Motor Pressure Regulating Valve
3500B and 3500B High Displacement Generator Set Engines Alternator
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Inlet Manifold - Remove - 3013, 3014, and 3024 Engines
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0546 - FMI 05 Ether Hold Relay open/short to ground
3500B and 3500B High Displacement Generator Set Engines MID 036 - CID 0546 - FMI 06 Ether Hold Relay short to +batt
3406E and 3456 Generator Set Engines Housing (Front) - Install
3406E Marine Engine Flywheel Housing
3406E Marine Engine Circuit Breakers
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Component Location
3406E and 3456 Generator Set Engines Coolant Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines Water Temperature Regulator - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines EMCP Electronic Control (Generator Set)
3512B and 3516B Engines Turbocharger
Electronic Modular Control Panel II (EMCP II) For PEEC Engines General Information
G3500 Engines Thermostatic Valve - Remove
Electronic Modular Control Panel II (EMCP II) For PEEC Engines Sensors
G3500 Engines Thermostatic Valve - Install
3500B and 3500B High Displacement Generator Set Engines System Configuration Parameters
G3500 Engines Thermostatic Valve - Disassemble