Water Temperature Indicator
Show/hide table
Illustration 1 | g01655193 |
Show/hide table
Pointer Position     | Test Temperature     |
A (1)     | 40 °C (104 °F)     |
B (2)     | 97 to 99 °C (207 to 210 °F)     |
C (3)     | 125 °C (257 °F)     |
Show/hide table
( 1 ) | The pointer must fall on the green zone or below the beginning of the green zone. |
( 2 ) | Lightly tap or vibrate the indicator in order to achieve the correct indication. |
( 3 ) | The pointer must not move beyond the end of the indicator band. The pointer must stop between 0 and −2.0 mm (−0.08 inch) of point (C) . |
Show/hide table
Illustration 2 | g01655213 |
(1) Final installation torque for two nuts ... 0.9 to 1.7 N·m (8 to 15 lb in)
Caterpillar Information System:
G3408 and G3412 Engines Ammeter
G3304 and G3306 Engines Overspeed Contactor
G3408 and G3412 Engines Voltage Control Relay
G3408 and G3412 Engines Service Meter
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Solenoid Valves
G3408 and G3412 Engines Circuit Breakers
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Electric Motor (Gearbox Oil Pump)
G3408 and G3412 Engines Pressure Switch
G3408 and G3412 Engines Magnetic Switch
G3606 and G3608 Engines Magneto - Remove and Install
G3408 and G3412 Engines Engine Oil Pressure Sender
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Pump (Gearbox Oil)
G3408 and G3412 Engines Engine Oil Pressure Indicator
G3606 and G3608 Engines Camshaft Drive Gear - Remove
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Transmitters
G3606 and G3608 Engines Camshaft Drive Gear - Install
P16, P20, P25, P28, P40 and P60 Pulverizers Rotary Manifold - Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Switches
Electric Protection System Energize-To-Shutoff (ETS) For Generator Set, Industrial and Marine Diesel Engines Troubleshooting the ETS Full Protection System (OP, WT, OS)
3408E and 3412E Engines for Caterpillar Built Machines Water Pump - Disassemble
G3606 and G3608 Engines Idler Gears (Rear) - Remove
G3606 and G3608 Engines Idler Gears (Rear) - Install
G3408 and G3412 Engines Ignition System
G3408 and G3412 Engines Air Inlet and Exhaust System