Overspeed Contactor
Show/hide table
Illustration 1 | g00579191 |
(1) Lock screw
In order to lower the overspeed setting, loosen the lock screws and turn the cap. View the cap from the terminal end of the contactor. Turn the cap in the clockwise direction.
The installed overspeed settings are the following values:
Show/hide table
Engine Rated Speed     | Setting for Overspeed ± 25 Rpm     | One-Half Of The Setting For Overspeed ± 12 Rpm     |
900     | 1062     | 531     |
1000     | 1180     | 590     |
1200     | 1416     | 708     |
1225     | 1445     | 723     |
1300     | 1534     | 767     |
1500     | 1770     | 885     |
1800     | 2124     | 1062     |
The contacts must close at the following speed. ... 118% of the speed that is rated for the engine ± 25 rpm
Bench test
The contacts must close at the following speed. ... one-half of the setting for overspeed ± 12 rpm
Caterpillar Information System:
G3408 and G3412 Engines Voltage Control Relay
G3408 and G3412 Engines Service Meter
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Solenoid Valves
G3408 and G3412 Engines Circuit Breakers
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Electric Motor (Gearbox Oil Pump)
G3408 and G3412 Engines Pressure Switch
G3408 and G3412 Engines Magnetic Switch
G3606 and G3608 Engines Magneto - Remove and Install
G3408 and G3412 Engines Engine Oil Pressure Sender
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Pump (Gearbox Oil)
3608 Engine Crankshaft Rear Gear - Remove and Install
G3408 and G3412 Engines Coolant Temperature Contactor
G3408 and G3412 Engines Ammeter
G3304 and G3306 Engines Water Temperature Indicator
G3408 and G3412 Engines Engine Oil Pressure Indicator
G3606 and G3608 Engines Camshaft Drive Gear - Remove
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Transmitters
G3606 and G3608 Engines Camshaft Drive Gear - Install
P16, P20, P25, P28, P40 and P60 Pulverizers Rotary Manifold - Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Switches
Electric Protection System Energize-To-Shutoff (ETS) For Generator Set, Industrial and Marine Diesel Engines Troubleshooting the ETS Full Protection System (OP, WT, OS)
3408E and 3412E Engines for Caterpillar Built Machines Water Pump - Disassemble
G3606 and G3608 Engines Idler Gears (Rear) - Remove
G3606 and G3608 Engines Idler Gears (Rear) - Install