| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | FT-3354 | Vacuum Cap | 1 |
Start By:
- Connect the steering frame lock.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Put identification marks on all harness assemblies, and on all tube assemblies for installation purposes. Plug all tube assemblies. This helps to prevent fluid loss, and helps to keep contaminants from entering the system.
- Release the system pressure. Refer to Operation and Maintenance Manual, "System Pressure - Release".
Show/hide table
Illustration 1 g06291077 - Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply
276 to 414 kPa (40 to 60 psi) . This procedure will pull a vacuum on the hydraulic system.Show/hide table
Illustration 2 g06330194 - Disconnect hose assemblies (2), (3), and (4).
- Remove bolts (5) and Gerotor Motor (Circle Drive) (5).
- Install Gerotor Motor (Circle Drive ) (5) in the reverse order of removal.